User manual

Operating instructions
D SCHWIMMSCHALTER
GB FLOAT SWITCH
F INTERRUPTEUR A FLOTTEUR
NL VLOTTERSCHAKELAAR
CZ PLOVÁKOVÝ SPINAČ
Technical specifications
• Float colour RED
to empty
(switch process: up ON, down OFF)
Microswitch / break contact
to pump
mains supply
to fill
(switch process: down ON, up OFF)
• Float colour WHITE
Microswitch / make contact
to pump
- mains supply
Cable H07RN-F3-G1, Ölflex 540-P3G1
Operating temperature max. 85° C
Mark of conformity VDE - ENEC - CE
Breaking capacity 10 (6) A - 250V ~
Float material non-toxic PP
Country of origin Germany
Always observe the following
• Connection and assembly of this product may only be carried out by a
trained electrician
• Before installing the switch, the system is to be disconnected from the
power supply: remove mains plug or switch off mains fuse
• Fixing point of float switch cable
at least 50mm from cable entry bush
• Never extend cable yourself!!!
• The cable end of the float switch must not be under water
as otherwise liquid might enter the switch
Connection
Colour blue = mains supply
Colour brown = to pump
Colour yellow/green = earth
With a cable length “L” of 20cm, for example, the upper contact travel is approx. 18cm, the lower
contact travel also approx. 18cm, the fill level height thus to be overcome between the lower and upper
actuation point is therefore approx. 36cm.
ON
OFF
ON
OFF
Contact travel (cm)
Contact travel (cm)