Use and Care Manual

Care of closet & mirror doors
GENERAL CLEANING
Clean with mild soap and water
Wipe dry with lint-free dry cloth
Dry door with separate cloth.
For mirror surface you may use a window cleaner and paper towels.
DOOR SURFACE CLEANING & HARDWARE LUBRICATION LABEL
REMOVAL Slowly peel from one corner. If label tears or sticks, moisten with
soapy water and gently scrape with plastic putty knife. Stubborn labels can be
soaked with soapy water and covered overnight with plastic wrap. Gently remove
with plastic putty knife. STUBBORN STAIN REMOVAL Commercial glass
cleaning products may be necessary. • Apply small amount directly to the stain.
Avoid spilling or dripping down the glass. • Some persistent stains may need
higher strength cleaning solutions that contain active ingredient chemicals such
as denatured alcohol or acetone. Special care must be taken when using these
types of cleaners. • For oil and grease: try baking soda and water.
Clean door surface and maintain hardware any time doors are not opening or
closing properly or at least biannually (monthly for coastal areas): • Clean
dirt/debris with mild soap and water and rinse clean.
Replace damaged hardware PRECAUTIONS The following substances may
damage protective finishes. Do not use: • Vinegar-based cleaners (use on glass
only) • Citrus-based cleaners (lemon, etc.) • Paint removers • Window cleaners •
Brick/siding washes • Any other industrial or abrasive cleaners
Folding doors: Tracks and Bearings Wipe visible track surfaces with a damp soft
cloth and a mild detergent, then wipe dry with a clean cloth. Using a suitable
applicator spread a small amount of clear petroleum jelly or similar lubricant
where the carrier wheels pass so that it is distributed evenly along the track.
The lubrication reduces wear, improves operation and protects against corrosion.
In severe environments, apply a thin film industrial lubricant. Hangers, Pivots and
Brackets Exposed surfaces should be wiped down with warm soapy water and a
soft rag, and then rinsed clean before applying new surface protectant. A light
spray application of WD40® , followed by a light wipe with a dry cloth to remove
any excess. Be careful not to get these compounds on any wood components as
it may cause staining. Cleaning and lubrication help to maintain and restore
smooth.
For a list of Colonial Elegance products or Installation Information, please visit
our website: www.colonialelegance.com