Instructions / Assembly

INSTALLATION GUIDELINES
REQUIREMENTS
BUILT-IN
Minimum clearances 2" on sides, 3" front and rear
LEVEL THE UNIT
Check level by holding top and right of machine and shaking it.
Adjust feet using wrench if required.
WATER PRESSURE
Standard water Pressure: 7.25-145 (psi) / 0.05-1(Mpa).
If more, reduce valves / install pressure reducing valves (Available)
Remove the 2 shipping rods located at the back of the unit.
REMOVE SHIPPING RODS
INSTALLATION
MODEL# 4400/N
DRIP PAN: It is recommended that all units have
drip pans for water safety. (Available)
PRE-INSTALLATION
ELECTRICAL: 110-120V/60Hz 13A
VENTED DRYING: Requires a standard 4” vent hose to be installed.
Appliance Desk • 10216 Georgibelle Dr, Suite 900D, Houston, TX 77043-5249
Toll Free: 1-800-490-8018 • Email: [e-mail] • www.ApplianceDesk.com
FLOOR: Strong level surface
CONDENSING
(VENTLESS)
Exhaust Fan Plate Installed
Display
Display
Exhaust Fan Plate Removed
Exhaust Duct Connected
VENTED
WATER: Standard hot and cold connections
SIDES FRONT/REAR
WOOD
CARPET
DRYING