Installation Instructions

Page 1 (cover) Page 2 (inside)
Page 3 (inside) Page 4 (back)
Black border shows
page size and should
not print
Black border shows
page size and should
not print
11.0"
8.50"
Features:
• Adjustable Thermostat
• Three Heat Settings:
(III) High - 1200 Watts (4096 BTU)
(II) Medium - 700 Watts
(I) Low - 500 Watts
• Front Mounted Control Panel
• Power Indicator Light
• Oil Permanently Filled
• Safety Tip-Over Cutoff Switch
• Durable Metal Body
• Silent Operation
• Stay Cool Handle
• 360° Swivel Wheels
• 120V A.C., 60Hz, 10A
Electric
Oil Filled
Radiator
Model #CZ7007J2
USAGE:
HEATER OPERATION: Always operate the heater in
the
upright position following all instructions and
recommendations
listed in this manual.
HEATER LOCATION: Place the heater
in the area of
the room that is coldest.
HEATER CONNECTION:
Plug heater directly into 120
volt A.C., 60Hz wall outlet. Be
sure plug fits tightly in
outlet. A loose connection may cause
overheating and
damage to the plug or heater. NOTE: To prevent
overloading a circuit, do not plug the heater into a
circuit that is servicing other electrical needs.
Make
sure heater is at least 3 feet away from walls,
furniture, and other obstacles.
TURNING HEATER ON: The power indicator light will
illuminate to show the heater is plugged in and has
electric power. Rotate power switch to desired
setting. The heater has three heat settings: 500, 700
and 1200 watts. Use the 1200 watt setting to raise the
room temperature quickly while thermostat control is
at its highest setting.
(During the heaters initial use, you
may experience
a slight odor or smoking. This is the
result of residual lubrication on the steel
“burning off”.
This is normal and will go
away after a few minutes of
use.) When desired temperature is reached, the 500
or 700 watt setting will be sufficient to maintain a
comfortable temperature.
Power Switch Positions:
O : Off position
I : Low - provides 500 watts of heat output
II : Med - provides 700 watts of heat output
III : High - provides 1200 watts of heat output
SETTING THERMOSTAT: After the unit has warmed
your room to a comfortable temperature, slowly rotate
the thermostat knob counter-clockwise until the
thermostat shuts off (you will hear a faint “click”
sound). Leaving the thermostat at this setting will
automatically maintain this temperature. For a lower
temperature, rotate the knob further
counter-clockwise.
TO TURN HEATER OFF: Rotate power switch to the
“O” position.
WHEEL ASSEMBLY INSTRUCTIONS:
The heater is packaged with wheels unattached. You
must attach them before operating the heater.
WARNING: Operate the heater only in upright
position (wheels on the bottom, controls on the top),
any other position could create a hazardous situation.
1. Turn the heater upside down.
2. The wheel brackets should be mounded to the far ends of
the heater.
3. Attach the Front Wheel Assembly to the front of the heater.
Note: the front wheels are angled and they should face the front
of the heater as shown in Fig. 1 and Fig. 2. Wrap “U” shaped
bolt around the connector between the first and second fins at
the front of the heater.
4. Slide the angled end of the “U” shaped bolt through the
outer holes of the wheel bracket as shown in Fig. 1.
5. Place threaded second end of the “U” shaped bracket
through the remaining outer hole and tighten down wing nut
securely (see Fig 2).
6. Attach second “U” shaped bolt around the last fin. Repeat
the connection process for the Rear Wheel Assembly as
shown in Fig. 3 and Fig. 4
Power
Indicator Light
Stay Cool Handle
Adjustable
Thermostat
4-Position
Rotary
Switch
Control:
•OFF
•LOW Heat
500 Watts
•MEDIUM Heat
700 Watts
•HIGH Heat
1200 Watts
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is not
intended for use in a bathroom, laundry area, or similar
locations, or near sinks, washing machines, swimming pools or
other sources of water. Never locate heater where it may fall
into a bathtub or other water container. Do not use heater
outdoors. Do not use in damp environments such as flooded
basements.
WARNING: HOT SURFACES
Do not touch body of heater when in use. This heater is hot
when in use, to avoid burns, do not let bare skin touch hot
surfaces. If provided, use handles when moving this heater.
WARNING: FIRE HAZARD
Heater has hot and arcing or sparking parts inside. Do not use
near combustible materials or flammable gases or sources of
heat. DO NOT USE in areas where gasoline, paint or
flammable materials are used or stored. Keep combustible
materials such as furniture, pillows, bedding, papers, clothes
and curtains at least 3 feet (0.9 m) from the front of the heater
and keep them away from the sides and rear. To prevent a
possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surfaces, like a bed, where openings may
become blocked. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may cause an
electric shock, fire, or damage the heater.
WARNING:
ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate
electrical system that is up to code.
The supply cord has a polarized plug. As a safety feature this
plug will fit in a polarized outlet only one way. To prevent
electric shock, match wide blade of plug to wide slot, fully
insert plug. If the plug does not fit contact a qualified
electrician.
Do not operate any heater with a damaged cord or plug or
after heater malfunctions, has been dropped or damaged in
any manner. Do not operate heater with a broken heating
element or ceramic cone or any visual imperfections. For
repairs covered under warranty, see warranty statement. For all
other repairs contact Comfort Zone® Customer Service by
telephone or mail for information and assistance.
PET OWNERS NOTE:
The health of birds and some small pets are extremely
sensitive to the fumes given off during the initial use of many
appliances. Although these fumes are not harmful to humans, it
is recommended that this heater not be used around birds and
small pets during its initial use until the manufacturing
corrosion coatings burn off.
INTENDED USE:
This product is intended for indoor residential and office use only, not
for industrial or other commercial application. Use only with electrical
wiring that is in good working order and that meets applicable codes
and ordinances. This heater must be plugged in to a 120V AC, 15 Amp.
(or larger) circuit. Do not plug anything additional into the same circuit.
If you have any questions whether your wiring is adequate, consult a
qualified electrician. Risk of fire, overheating, malfunction, property
damage, injury or even death may result if not adhered to.
Use your heater only with a working smoke detector located in the
vicinity of your heater.
While using your heater, you should follow the IMPORTANT
INSTRUCTIONS listed below. As part of those instructions, we have
used the word “WARNING” to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided, could result in
injury or death.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock and injury to persons,
including the following:
• Read all the instructions before using this heater.
• This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Use provided handle when moving this heater.
Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes and curtains at least 3 feet (0.9 meters) from the
front of the heater and keep them away from the sides and rear.
• Do not use heater unattended. Use of extreme caution is necessary
when any heater is used by or near children, invalids, disabled
persons or pets.
• Do not operate the heater with a damaged power cord or after the
heater malfunctions, has been dropped or damaged in any manner.
Return heater to authorized service facility for examination, electrical
or mechanical adjustment or repair.
• Do not use heater outdoors.
• Use your heater only in dry environments. This heater is not intended
for use in a bathroom, laundry area, or similar locations, or near
sinks, washing machines, swimming pools or other sources of water.
Never locate heater where it may fall into a bathtub or other water
container. Do not use in damp environments such as flooded
basements.
• Do not place the heater on a small, unlevel, uneven or any surface
which might allow heater to tip or fall.
• For proper operation, heater should be placed on a smooth,
non-combustible surface. Do not place on rugs, carpet, vinyl flooring
or other plastic surfaces. Not for use outdoors or in wet areas.
• This heater is not designed as a primary heat source.
• Always plug heaters directly into a wall outlet/receptacle. Never use
with an extension cord or relocatable power tap (outlet/power strip).
Always unplug heater when not in use.
• Do not run power cord under carpeting. Do not cover cord with
throw rugs, runners or similar coverings. Arrange cord away from
traffic area where it will not be tripped over.
• To disconnect heater, turn controls off then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire or
damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces like a bed, where openings may
become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint or flammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock or
injury to persons or property.
SAVE THESE INSTRUCTIONS
LIMITED WARRANTY
This unit is guaranteed to the original retail purchaser against defects in quality or workmanship for a period of
one year from the date of original purchase. If this unit fails because of a manufacturing defect within 30 days
of purchase, return the unit, with your receipt, to the retailer. After 30 days, but within the warranty period, if the
unit was purchased within the continental United States, return it, freight prepaid, to World and Main for repair
or replacement. If the unit was purchased outside the continental United States, return the unit to the place of
purchase. This warranty does not cover damage caused by misuse, abuse, overheating or alteration. Repairs
made by anyone other than World and Main are not covered in this warranty. World and Main will not be held
liable for any losses due to neglectful operation. All implied warranties, including the warranties of
merchantability and of fitness of purpose, if applicable, are hereby limited in duration to the period of one year
from the date of original retail purchase. Some states do not allow limitations on how long an implied warranty
lasts, so the above limitations may not apply to you. Incidental or consequential damages arising from a breach
of either express or implied warranties are hereby disclaimed and excluded. Some states do not allow the
exclusion of limitation of incidental or consequential damages, so this limitation or exclusion may not apply to
you. Upon the expiration of this warranty all such liability will terminate. No other warranties are expressed or
implied.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
No informal dispute settlement mechanisms are available. This limited warranty is given in lieu of all other
warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneproducts.com
Rev. 032019
Save These Instructions
IMPORTANT SAFETY FEATURES:
The power indicator light, located near the control panel,
lights whenever the heater is turned on. The heater is
equipped with an automatic overheat protection device
located inside the body of the heater. If the heater grille is
obstructed, or if the heater gets too hot for any reason, the
automatic overheat protection device will turn the heater off.
To reset the heater, simply turn power off and unplug the
heater for 10 minutes until it cools down and then you may
plug the heater in and restart. Be sure that the heater is on a
smooth level surface with no obstructions.
The heater is also equipped with a safety tip-over switch to
turn power off to the heater when the heater tips over. The
unit will shut off automatically. To resume heater functions
simply stand heater upright and follow operating instructions.
CARE AND MAINTENANCE
CLEANING
: CAUTION-Before cleaning the heater be sure to
disconnect power cord and allow the heater to cool
completely. This heater should be cleaned at least once a year
to maintain proper performance. Clean the outside surface
with a clean damp cloth. Do not use harsh chemical or
abrasive cleaners. DO NOT IMMERSE THE HEATER IN
WATER. Allow heater to dry completely before use.
REFUELING:
This heater is factory sealed and never needs
refueling.
REPAIR:
DO NOT OPERATE THE HEATER WITHOUT ANY OF THE
SAFETY FEATURES IN PLACE. DO NOT USE THE HEATER
IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN
ANY WAY.
STORAGE: Keep original carton for storage of the heater.
Coil the power cord around the built-in cord storage
compartment to avoid damage during storage.
Pg. 1 Pg. 2
Pg. 3 Pg. 4
Fig. 1
Fig. 2
Rear Wheel Assembly
Front Wheel Assembly
Fig. 3
Fig. 4