Installation Guide

NOTE: MOUNT POWER UNIT SUCH THAT CORD
MAY BE DIRECTLY PLUGGED INTO RECEP-
TACLE, OR HAVE A NEW RECEPTACLE IN-
STALLED. DO NOT USE AN EXTENSION CORD.
MODEL CV3200/CV3300/CV3400P
Exhaust
Use PF-242
45° Street Ell
INSTALLATION - PLASTIC CONE
The plastic cone is necessary for proper separation. For
single ring unit installation the tilted cone is pushed up
inside the unit so that the lip of the lower edge of the cone
rests on the first lower rib of the can(Figure 1). Then, the
high-side of the cone is pulled down gently to seat on the
top of the lower rib. The entire edge of the cone should
now rest on the top of the rib(Figure 2). For double ring
unit installation the tilted cone is pushed up inside the
unit. The lower lip is then brought down and placed in
between the two lower rings (Figure 1A). Then the cone
is tilted level and pulled down until the complete lip pops
in place between the two lower rings (Figure 2A).
Main Housing Assembly
TOP CAN
TOP CAN
FIGURE 1 FIGURE 1A
White Plastic Cone
Main Housing Assembly
White Plastic Cone
FIGURE 2 FIGURE 2A
Rib
Rib
TYPICAL INSTALLATION - POWER UNITS
NOTE: Exhaust should be vented outdoors using 2" tubing - Exhaust air should not be vented
into a wall, ceiling or a concealed space of a building. Mount power unit such that cord may be directly
plugged into receptacle or have new receptacle installed. DO NOT use an extension cord.
CV0003 effective 02/11 PRINTED IN USA
MODEL CV3500
Vacuum
Exhaust
6" min.
to sidewalls
24-1/4"
9-1/8"
6"
41-1/4"
14-1/2"
8-1/8"
4-3/4"
6"