Use and Care Manual

ManualsBrandsUnbranded ManualsGame RoomTabletop Foosball Set

WARNING: To ensure your safety, please do not attempt to assemble this product without

reading this instruction manual carefully. Failure to comply with this warning may result in

injury and/or property damage.

• This product includes small parts/accessories that are not suitable for children under 3

years of age as they may cause a choking hazard.

• This product should be assembled by an adult.

• Please check that all hardware is ﬁtted tightly prior to use of this product.

• Only use this product on a level surface.

• This product is designed for indoor use only.

For parts and service enquiries, please contact Action Spares on 1800 465 070 or e-mail

service@actionspares.com.au

Mini Foosball Game

S002296

Instruction Manual

Summary of content (6 pages)

PAGE 1
Mini Foosball Game S002296 Instruction Manual WARNING: To ensure your safety, please do not attempt to assemble this product without reading this instruction manual carefully. Failure to comply with this warning may result in injury and/or property damage. • • • • • This product includes small parts/accessories that are not suitable for children under 3 years of age as they may cause a choking hazard. This product should be assembled by an adult.
PAGE 2
Parts List T1 T2 T3 T4 E1 4 pieces 2 pieces E2 E3 2 pieces 1 piece E5 A1 4 pieces 8 pieces E4 2 pieces A2 A3 4 pieces 4 pieces B1 B2 B3 Allen Key Soccer Ball 8 pieces 4 pieces 4 pieces 1 pieces 2 pieces 2 S002296 Mini Foosball Game
PAGE 3
Assembly Instructions Step 1 Use 4 screws (B1) to attach two short boards (E1) and one long board (E2) with Allen Key (included). E1 E2 B1 Step 2 Insert the playing surface (E3) into groves of the assembled pieces from step 1 as shown.
PAGE 4
Assembly Instructions (cont) Step 3 Install the (A1) to T1, T2, T3 & T4. A1 A1 Step 4 Install the bars (T1,T2,T3 & T4) into the predrilled holes along the long board.
PAGE 5
Assembly Instructions (cont) Step 5 Position the remaining long board (E2) and attach securely as in step 1. E2 B1 Step 6 Attach the four handles (A2) and bar caps (A3) as shown and press firmly into place.
PAGE 6
Assembly Instructions (cont) Step 7 Insert part (B3) into handle and screw into place. A2 Step 8 Line up part (E4) to pre drilled pilot holes and attach using parts (E5) with B2.