PRODUCT ASSEMBLY Hardware List 1p6 K piss Cam-obit Magnetic Catch Hinge B & 12 pes W 32 pes L 1pe Car-dork Resew radiomen Skibob Bolt c Sy 26 pos M 2 pes M 3 1pc Wood Dowel Resew showroom Kris pes X 1p0 N 4 pos Resew e Magnetic Bar Stepper E Ty 13 pes P 25 pes O < 4 pes Resew Diem Sure 555 Shelf Pin Parts List Divide Daniel Left Back Panel Hottie Pansy Di rawer Bottom Panel 2 1pe 10 apes Bottom Connect Bar Drawer Back Pang! e 3 o 1pe 11 Pics e P [l Connect Bar Connect Bar 4 2 ficus 12 1pe Left Side Parcel D
PRODUCT ASSEMBLY 2 pes Step 1 apes a} insert Wood Dowel (C) 1o the designated hols on Divide Panel{1). b} Almach {1) to Bolton Panel {2) via Wood Dowels, then fix by sting Resew (H). A & 1pe Step posts 3) Resew in Cam-blat (A) Into designated holes on Divide Panel (1), £} Insert Wood Dowel {C) to the designated holes on Connect Bar (4 & 12). <) Attach via Ga-bolts and Wood Dowels, o) Insert Cam-Lock (B) to the designated holes on £12), then tum clockwise to fork onto Cam-bolt, Do not over tighten.
PRODUCT ASSEMBLY apes pes &) Resew in info designated holes on Lat Side Anal (8}, B Insert Wood Dowel (G} 1o the . designated holes on (2,4 & 12). attach via Cam-obits and Wood Dowels, d) Inset Cam-Los (8} to the designated Holes then turn clockwise o rock onto Cam-obit. Do not over tighten.
PRODUCT ASSEMBLY 2 pes Step 5 2 pes 4 Resew n into designated holes on P Right Side Panel (5). pes ) Insert Wood Dowel (0) to the designated holes on{2 %8 ) Attach via Cam-obits and Wood Dowels. o) Insert Arm-Lodk (B to the designated holes on (2}, then turn clockwise fo lock ante Cam-biol. Do not brightener. A @5/@ 6 pes Step pos C| ™, | poss D ;:Kl 2 pos E A Zmm 4 pos F gfié@‘ 1pe N 4__/y 4 pes @) Brew in Cam-bolt (A) into designated holes on Top Pane! (8).
PRODUCT ASSEMBLY Step [opes Attach Back Panel using Screw & pos Step 8 1pe . 2 pes &) Attach Hinge {K) and Magnetic Bar ()40 Door using Borrow (E) as show. 1pe ) Attach Door (14) fo Right Side Fang {7} by using Boru (E) as show it, ) Attach Knee (M) 1o Door (14) by using Knob Bolt (.
PRODUCT ASSEMBLY ¢ pests o Step 9 a) Attach Drawer Side Panel (8) fo Drawer Back Panel (11} and Drawer Front Pail (13) by using Screw(3) as shown. Do not Over tighten. Note: the groove on each panel is al the bottom. Y Insert Drawer Bottom Panel{10) to Drawer Panels (8, 11.& 18) via groove on respective Drawer Panels. ) Attach Drawer Side Parietal (8)to using Resew D4 nit Tightener. O =& PCs Step 10 insertions Pin {0) and place Adjustable Shelf (15) obit. The assembly of the Cabinet unit is complete.