Instructions / Assembly

Contents:

Qty. Description

1 Top Section

2 Seat Section

4 2" x 6" Legs

2 2" x 4" x 61" Seat Beams

2 1 1/2" Sq. Braces

48 1" Screws

1 Instruction Sheet

Move all components except the top of the table to the

lid of the box. Place the lid, with the table top, on a flat

surface and tear the box at the corners for easier access.

Position the legs of the table on

the cross rails of the top with the

notch of the leg inward.

Pass the seat beam through the legs, leaving 11 3/4" on

both sides as shown.

Predrill the legs into the top cross rail.

PICNIC TABLE

SuperiorPlasticProduc ts.com

PAGE 1
PICNIC TABLE SuperiorPlasticProducts.com Contents: Qty. 1 2 4 2 2 48 1 Description Top Section Seat Section 2" x 6" Legs 2" x 4" x 61" Seat Beams 1 1/2" Sq. Braces 1" Screws Instruction Sheet 1 Move all components except the top of the table to the lid of the box. Place the lid, with the table top, on a flat surface and tear the box at the corners for easier access. 3 Pass the seat beam through the legs, leaving 11 3/4" on both sides as shown.
PAGE 2
Secure the seat beam to the table leg with screws. 5 Drive screws into the cross rail on both the outside and inside face of the leg as shown. 6 7 8 Position the table leg brace in the center to the seat beam. Secure the brace to the beam with screws. Using the same measurement from the previous step, position the brace on the center of the table top. Make sure that the legs are square to the top and screw in place. Anything square can be used to perform the last step, including the back of a tablet.