User manual

Sharp-edged bends up to an angle of 90° can be made with the help of the
quater mandrel.
The quater mandrel is fitted into the
device instead of the standard mandrel.
The flattened site of the quater mandrel
shows towards the guide plate. The
operations with the quater mandrel are
similar to those with the standard
mandrel. However please note that the
thickness of the material must not exceed 3mm (reffering to steel 37).
3.3. Bending pipes and other round material
Bending pipes and other round material is possible up to a maximum of
10mm Æ.
The device should be prepared as follows:
- Turn the guide plate around so that both v-shaped furrows become visible.
After that lock the guide plate into place again with the angle bolt.
- Place the rack into the body so that the gaps on the end show towards the
standard mandrel.
- Attach the bending disk with the desired diameter of of your pipe onto the
standard mandrel. Bending disks with diameters of 4, 6, 8 and 10mm belong
to the set of supplied accesories of the “Universal” bending machine.
Please choose upper or lower gap in the rack appropriate to the thickness of
the pipe for better grip. In addition keep in mind that bending pipes and other
round material is only possible up to an angle of 180°. Bending round material
(solid material) is not only possible with the bending disks but also with the
standard or change-over mandrel.
4. Maintenance
Avoid any overstrain at all costs. Extending the handle lever to increase
bending power is forbidden. Worn-out parts should be replaced immediately.
Mobile parts should alwayd be kept clean.
5. Technical data
Bending performance : flat material up to 40 x 4mm
pipes up to 10mm Æ
solid material up to 10mm Æ
Weight : 4 kg
Subject may change without notice in case of technical improvements.
Handyman’s bending machine
’’Universal”
Art. No.: 110 010
Instruction Manual
Abb. 2