Datasheet

ECV-2302-RJ
VDSL2 Long Reach Ethernet Extender
Introduction
This device is a Long Reach Ethernet Extender with one Ethernet port (on 1 RJ-45 connector) and one VDSL2 port on 1 RJ-11 connector. This
extender is a bridge mode modem accommodating well proven Ethernet and VDSL2 technologies to extend Ethernet over single-pair phone line
by using a VDSL2 signal. Up to 100/60 Mbps (or 90/90 Mbps with synchronous data rate) transition bandwidth within 300m and 40/10 Mbps for
1km long range connections that provides ultra-high performance to the pervasive telephone line network. Its plug-n-play solution minimum
installation time & cost by allowing video streaming and data to share the same telephone pair without interference.
With one DIP switches configuration, the Extender including the CO (Central Office) site and CPE (Customer Premise Equipment) site. It supports
high bandwidth VDSL2 over existing telephone wires in the “last mile” from the ISP / Telecom / Service provider’s fiber mode to the buildings and
customers’ home.
Technical Specifications
Standard
IEEE 802.3 10BaseT
IEEE 802.3u 100BaseTX
ITU-T G.993.2 (VDSL2)
Interface
Ethernet: 10/100Base-TX RJ-45 Connector, Auto-MDI/MDI-X
ECV-2302: RJ-11 female Phone Jack
MAC Address: 2K
Transmission Method: Store and Forward
Data Transfer Rate
0 m-100 Mbps
350 m-100/60Mbps
1 km-40/10Mbps
DIP
DIP 1 (Mode): ON=CO, OFF=CPE mode
DIP 2-3: OFF-OFF= Annex A-30a(default); OFF-ON= B-30a-997
ON-OFF= Annex A-17a; ON-ON= B-17a-997
DIP 4 (SNR Control): ON=6dB, OFF=9dB
LED
Power, CO, VDSL Link/Negotiation
Ethernet Link/Act, Speed, Duplex
Power Supply
Power Adapter: 100~240VAC to DC 12 Volt Output
5.5/2.1mm DC Jack on Board
Power Consumption
4.2 Watt maximum.
Operating Temperature
0 to 45℃
Humidity
10 to 90% RH (non-condensing)
Dimension
102 × 75 × 23 mm (L x W x H)
Weight
0.21Kg
Certification
CE, FCC Class A