Instructions / Assembly

ManualsBrandsUnbranded ManualsDoor Bells75 dB Wireless Plug-In Door Bell Kit with 1-Push Button, White

HOMEDEPOT.COM

Please contact 1-855-556-1852 for further assistance.

Use and Care

Guide

Wireless Plug-In

Doorbell Kit

ITEM #1001 406 888

MODEL #216603

Installation

ACTIVATING THE PUSH BUTTON

BATTERY

□ Remove the front cover of the push

button by inserting a ﬂat head

screwdriver in the slot on the bottom

of the button and pulling up slightly.

□ Remove the plastic tab from the

battery compartment to allow

connection to the terminal.

□ Snap the front cover onto the base by

ﬁrst hooking the tops together, then

snapping the base on.

PLUGGING IN THE CHIME

□ Plug the door chime into any outlet

in the house, ensuring it is within

the transmission range of the push

button location.

SYNCING THE CHIME AND PUSH

BUTTON

The chime and included push button

already come synced. Follow the steps

below if you need to resync, or sync

additional push buttons.

□ Press and release the learning button

on the chime.

□ Immediately following, press and

release the push button to hear a

2-note tune. Press and release the

push button again within ﬁve seconds

to hear another tune. Continue

pressing and releasing the push

button until you reach the desired

tune. To set that tune, do not push the

push button for ﬁve seconds.

216603Inst.ai

Learning

mode

button

TOOLS REQUIRED

Phillips screwdriver Flat Head Screwdriver Drill

HARDWARE INCLUDED

#4x3/4

#6x3/4

#4x1 White Zinc

#6x1 Self Tapping

ScrewHardware.ai

(2) #4 x 3/4 in. Screws (1) Adhesive Sticker

216603Inst.ai

Learning

mode

button

5/64” Drill Bit

216603Inst.ai

Learning

mode

button

216603Inst.ai

Learning

mode

button

#4x3/4

#6x3/4

#4x1 White Zinc

#6x1 Self Tapping

ScrewHardware.ai

Summary of content (3 pages)

PAGE 1
Wireless Plug-In Doorbell Kit Use and Care Guide ITEM #1001 406 888 MODEL #216603 #4x3/4 TOOLS REQUIRED HARDWARE INCLUDED #6x3/4 #4x3/4 Phillips screwdriver Flat Head Screwdriver Drill (2) #4 x 3/4 in. Screws (1) Adhesive Sticker #6x3/4 #4x1 White Zinc #6x1 Self Tapping 5/64” Drill Bit Installation 1 Learning mode button #4x1 White Zinc ACTIVATING THE PUSH BUTTON BATTERY 2 □□ Remove the front cover of the push button by inserting a flat head 216603Inst.
PAGE 2
4 5 MOUNTING THE PUSH BUTTON □□ Remove the front cover from the base by following step 1. □□ Mount the push button base to a clean wall or door jamb with included screws or mounting tape. If mounting with screws, predrill a pilot hole through the push button base in the desired location using a 5/64 in. drill bit. □□ Snap the push button cover onto the base by first hooking the tops together, then snapping the base on.
PAGE 3
WHAT IS NOT COVERED Warrantor shall have no further liability or obligation except as expressly stated herein. This Warranty does not apply to any Doorbell Product that has been abused, misused, modified, subjected to abnormal use conditions, stored improperly prior to installation, or otherwise used in any way not intended by Warrantor.