Installation Instructions

Create a trendy industrial-style coffee table for your home!

Follow these steps below for our design or create your own

unique look!

SHOPPING LIST

Step 1: Stain wood surface

Lay down a drop cloth if desired and ensure that the wood

is clean and dry. Using a brush, apply stain. Make

brushstrokes in the same direction as the woodgrain. Use a

rag to remove any excess stain and allow time to dry.

Step 2: Clean pipes

Remove labels and wipe down the pipes with a spot remover

to remove sticker residue or grease.

1/2-inch black

pipe floor flange

Edge glued board

(103-5016)

Minwax

Wood

Finish (555-7561)

Stain brush

(561-0928)

1/2” x 8” nipple

(686-1046)

Polycrylic finish

(555-8048)

Clear finish brush

(561-0520)

Goof Off

Remover

(561-4139)

1/2-inch tee

(686-1028)

(686-1026)

1/2” x 36” cut

black

pipe

(686-1051)

1/2” x 10” nipple

(686-1047)

#10 x 5/8” panhead

wood screws [25 pk]

(234-6319)

PAGE 1
Create a trendy industrial-style coffee table for your home! Follow these steps below for our design or create your own unique look! SHOPPING LIST Edge glued board (103-5016) Polycrylic finish (555-8048) 1/2-inch black pipe floor flange (686-1026) 1/2” x 36” cut black pipe (686-1051) Minwax® Wood Finish (555-7561) Clear finish brush (561-0520) 1/2-inch tee (686-1028) 1/2” x 10” nipple (686-1047) Stain brush (561-0928) Goof Off® Remover (561-4139) 1/2” x 8” nipple #10 x 5/8” panhead wood screws [
PAGE 2
Step 3: Leg assembly Starting with a 1/2-inch floor flange, securely screw an 8inch pipe into the threaded end of the flange. Attach a 1/2inch tee to the other side of the pipe, followed by another 8-inch pipe and another floor flange. Repeat this assembly for the other three legs. Step 4: Begin frame assembly Lay out the two legs that you just assembled. Screw a 10inch pipe into the open end of the tee on each leg. Connect the two legs by attaching another tee; repeat this step for the remaining two legs.