Instructions / Assembly

1. Select installation orientation: installing
horizontal or vertical.
2. Using a level, draw a line on the wall for
the Starter Plank.
3. With the Starter Plank (pre-cut 8” or 16”
length) face down, apply one piece of tape to
the left side in the center of the plank. Then
apply two pieces to the right side overhanging
the plank (See picture).
4. Line up the starter plank with your line on
the wall. Stick the plank (pressing firmly) on
the wall.
5. For the Next Plank, apply two pieces of
tape to the right side overhanging the edge
as you did on the Starter Plank.
6. Line up the vertical edges of the Starter
plank and the Next plank. The Next Plank
will cover the overhanging tape on the starter
plank. No gap is required between boards.
Press firmly to the wall.
7. Continue installing planks across the wall using the same method of two planks sharing
two pieces of tape. Again, no gaps are necessary. Boards may touch on all sides.
8. When you come to the end of the row, use
the pre-cut (8” or 16” length) Finish Plank with
one piece of tape centered on the right side
of the plank.
*Notes: The pre-cut pieces allow for
staggering seams. The 8” or 16” may be
used as the Starter/Finish Plank.
Alternating them creates a gorgeous wall
design. They may also be used
anywhere in a row to stagger the seams.
You may cut full planks to desired lengths
as well using a hand saw or power saw
(fine tooth blade recommended).
INSTALLATION INSTRUCTION