Instructions / Assembly

3D Wall Panels | Installation Guidelines

Materials and Tools:

Level Ruler Pencil Glue/ Adhesive Brush Spackling Clean cloth Stiletto

Conditions for installation:

The wall must be Clean (clean cloth to remove dust) and Smooth (not contain high relief textures or paper wall)

Follow the steps:

1. Simulate the positioning of the panels on the wall and

make sure there is a need for trimming.

2. With the level and ruler, draw vertical and horizontal

lines on the wall to mark where the panels will be glued.

3. Pass the glue on the wall and the back of the panels

(in the flat parts of them).

We recommend these types of glue/ adhesive:

 Loctite PL Premium Polyurethane Construction

 Loctite Power Grab Ultimate

 Evo-Stik / Nail Free Adhesives

 Quart Suregrip 122 Heavy

Read the instructions of the glue you are using.

4. Glue the panels respecting the lines drawn, with the

spacing of 02mm between them. You can start the

collage by the center or sides.

5. The cutout for plugs and mirrors can be made with

stylet or scissors. Mark the back of the panel where it

will be cut for ease.

PAGE 1
3D Wall Panels | Installation Guidelines Materials and Tools: Level Ruler Pencil Glue/ Adhesive Brush Spackling Clean cloth Stiletto Conditions for installation: The wall must be Clean (clean cloth to remove dust) and Smooth (not contain high relief textures or paper wall) Follow the steps: 1. Simulate the positioning of the panels on the wall and make sure there is a need for trimming. 2.
PAGE 2
6. If desired, the joints can be finished using Spackling . Wipe off excess using a clean cloth. Wait to dry before painting (approximately 12 hours). 7. For painting, follow the guidelines below: Materials for painting: Newspaper for protection Paint sprayer Panteirs tape Paint (we recommend synthetic solvent based namel) Painting: 1. Apply paint with a Paint sprayer . 2. Before you start painting, test the distance and control flow on a piece of cardboard.