User's Manual

Ultra Electronics Card Systems Quick Start Guide

MAGICARD Sprinter Flip Page 37

1. Hinge down the Pull-down Card Tray. Hinge down the Front Cover and lift up the Top

Cover to the vertical position, and remove the Cassette. Switch ON the power supply.

2. Get the motor to turn the rollers by operating the Cover Microswitch in the hinged cover,

by hand. Allow the motors to achieve full operating speed before applying the Cleaning

Card to the rollers, otherwise the motors will stall and the rollers fail to turn.

3. Clean the Front Rubber Drive Roller every 1000 cards printed or if mis-registration occurs.

Open a fresh solvent impregnated Cleaning Card and clean the Front Rubber Drive Roller

by inserting the Cleaning Card from the front with the impregnated side faced down, with

the rollers turning so that the roller turns against the Cleaning Card as shown in Position

4. Clean the Printhead Roller, normally positioned beneath the Thermal Printhead, by

applying the Cleaning Card (with the impregnated side faced down) to the visible surfaces

of the Printhead Roller so that the roller turns against the Cleaning Card as shown in

Position D.

NOTE Discard the Cleaning Card when it has dried out. One or two cards should be

sufficient to carry out these instructions.

5. Clean the Rear Rubber Drive Roller by inserting the Cleaning Card with the impregnated

side faced down, from the rear with the rollers turning (ie, beneath the Card Preventer

and the Sticky Roller) so that the lower roller turns against the Cleaning Card as shown in

Position E.

6. Clean the Card Feed Rollers every 1000 cards printed or if problems occur with cards

feeding from the Cassette. Using the Cleaning Card clean the two Card Feed Rollers.

One is normally beneath the Card Cassette and the other is close to theSticky Roller.

These rollers are geared together and cannot be turned by operating the Cover

Microswitch as above. Turn one Card Feed Roller by hand whilst applying the Cleaning

Card, with the impregnated side faced down, to the other Card Feed Roller. Repeat the

cleaning process for the other Card Feed Roller as shown in Positions B and C.