Data Sheet

45643 20190303
UHU GmbH & Co. KG 77813 Bühl (Baden) Tel.: [phone] Fax [phone]
www.uhu.com
Note: This information is the result of carefully executed tests. This Technical Data Sheet has been prepared to the best of our knowledge to provide you with advice when gluing. We cannot be held responsible for the
results or any damage suered, as the variety of factors involved (type and combination of materials and working method) are beyond our control. Users have to carry out their own checks and trials. Liability can only be
accepted for the consistently high quality of our product.
Universal strong dUal-component epoxy adhesive
plUs endfest
45643  UHU PLUS ENDFEST 300 BLISTER 33 G DE / FR / GB  45640
Directions for use:
Press out an equal amount of both components onto the enclosed mixing
tray. Mix these two equal parts well with a synthetic spatula until a mixture
is obtained with a homogeneous colour. Apply the mixture, which at room
temperature (+20°C) remains toolable for about 1.5 hours, as a thin layer on
one of the two materials. Join the materials and keep them in place for 7 hours.
Be careful not to move the parts before the adhesive has cured. Resin and
hardener must not come into contact with each other unless for usage.
Potlife: 90 minutes
Stains/residue: Remove wet stains immediately with warm water and soap.
Cured adhesive residue can only be removed mechanically.
Advice: Some types of synthetics can not be joined such as polyethylene and
polypropylene. This can be tested by holding a glowing copper wire against the
synthetics. Does it smell of wax? Then you can not bond it.
Use a piece of adhesive tape in order to keep the parts in place while the
adhesive is curing.
PRODUCT DESCRIPTION
Universal strong dual-component epoxy adhesive.
FIELD OF APPLICATION
Ideal for repairs to metal, ceramics, porcelain, crystal, glass, ivory, pearls,
precious stones and various synthetics (polyester, bakelite, formica, rigid
polystyrene and acrylic glass (Perspex®). Not suitable for Polyethylene (PE),
polypropylene (PP), PTFE and silicone rubber.
PROPERTIES
· Super-strong
· Resistant to temperatures between -30°C and +80°C
· Filling
· Water resistant
· Chemical resistant
· Paintable
PREPARATION
Working conditions: Only apply at temperatures between +5°C and +35°C.
Product cures by mixing the resin and hardener.
Personal safety: Preferably wear gloves.
Surface requirements: The materials to be bonded must be dry, clean, free of
dust and grease.
Preliminary surface treatment: Degrease parts to be bonded with acetone.
Roughen smooth surfaces (sandpaper).
Tools: Mix the components by means of the supplied mixing bowl and spatula.
APPLICATION
Mixture ratio: 1:1 (by volume)
Coverage: 1 ml = approx 1 cm² at a lm thickness of 1 mm