MSDS

MATERIAL SAFETY DATA SHEET
PRODUCT NAME: DRYLOK EXTREME – ALL COLORS HMIS CODES: H F R P
PRODUCT CODE: 670 -671 1 0 0
SECTION I – MANUFACTURER IDENTIFICATON
MANUFACTURE’S NAME: UNITED GILSONITE LABORATORIES EMERGENCY PHONE: [phone]
ADDRESS: 1396 JEFFERSON AVENUE
SCRANTON, PA 18509 INFORMATION PHONE: [phone]
NAME OF PREPARER: R. BARAKO
DATE ISSUED: APRIL 2013
SUPERCEDES: APRIL 2010
SECTION II – HAZARDOUS INGREDIENTS/SARA III INFORMATION
OCCUPATIONAL EXPOSURE LIMITS VAPOR PRESSURE WEIGHT
HAZARDOUS COMPONENTS CAS NUMBER OSHA PEL ACGIH TLV OTHER mmHg@TEMP PERCENT
WATER 7732-18-5 NOT ESTAB NOT ESTAB NOT ESTAB 1.0 (68F) 33
*DIETHYLENE GLYCOL MONO-
METHYL ETHER 111-77-3 NOT ESTAB NOT ESTAB NOT ESTAB 0.1 (68F) 3
DIETHYLENE GLYCOL BENZOATE 120-55-8 NOT ESTAB NOT ESTAB NOT ESTAB <1 (68F) 0.50
PROPANOL OXYBIS – DIBENZOATE 27138-31-4 NOT ESTAB NOT ESTAB NOT ESTAB <1 (68F) 0.50
STYRENE ACRYLIC RESIN 25036-16-2 NOT ESTAB NOT ESTAB NOT ESTAB N/A 15
TITANIUM DIOXIDE 13463-67-7 15 MG/M
3
10 MG/M
3
NOT ESTAB N/A 10
NEPHELINE SYENITE 37244-96-5 5 MG/M
3
(1) NOT ESTAB NOT ESTAB N/A 13
WOLLASTONITE 13983-17-0 15 MG/M
3
10 MG/M
3
NOT ESTAB N/A 18
ENCAPSULATED COPOLYMER 25214-39-5 NOT ESTAB NOT ESTAB NOT ESTAB N/A 3
DIPROPYLENE GLYCOL MONO-
BUTYL ETHER 29911-28-2 NOT ESTAB NOT ESTAB NOT ESTAB .06 (68F) 2
YELLOW IRON OXIDE 51274-00-1 NOT ESTAB 10 MG/M
3
NOT ESTAB N/A 1
BLACK IRON OXIDE 1317-61-9 10 MG/M
3
5 MG/M
3
NOT ESTAB N/A 1
(1) Time Weighted Average
• Indicates toxic chemical(s) subject to the reporting requirements of Section 313 of Title III and of 40 CFR 372
SECTION III – PHYSICAL/CHEMCIAL CHARACTERISTICS
BOILING RANGE: 212 F SPECIFIC GRAVITY (H20 =1) 1.26
VAPOR DENSITY: HEAVIER THAN AIR EVAPORATION RATE: SLOWER THAN ETHER
COATING VOC: LESS THAN 100 G/L
SOLUBILITY IN WATER: SOLUBLE
APPEARANCE AND ODOR: WHITE OR COLORS, PRODUCT SPECIFIC. TYPICAL AMINE ODOR
SECTION IV – FIRE AND EXPLOSION HAZARD DATA
FLASHPOINT: N/A METHOD USED: N/A
FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: 1.7% UPPER: 22.0%
EXTINGUISHING MEDIA: NONE KNOWN
SPECIAL FIRE FIGHTING PROCEDURES: CONTAINERS MAY SWELL AND BURST DURING A FIRE DUE TO INTERNAL PRESSURE CAUSED BY
HEAT. THIS MAY CAUSE A SLIPPERY CONDITION ON FLOORS
UNUSUAL FIRE AND EXPLOSION HAZARDS: N/A
SECTION V – REACTIVITY DATA
STABILITY: PRODUCT IS STABLE
CONDITIONS TO AVOID: TEMPERATURES BELOW 32 (F) FOR STORAGE. TEMPERATURES BELOW 50 (F) FOR APPLICATION
INCOMPATIBILITY (MATERIALS TO AVOID): N/A
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: N/A
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR