User's Manual

Digital VHF HB Driver/Transmitter Chapter 3, Site Considerations,
w/Axciter Modulator Installation and Setup Procedures
LX Series, Digital, Rev. 0 3-10
Table 3-4: Menu 02- Splash Screen #2
This is the second of the two transmitter splash screens. This screen will automatically
switch to the Main Screen. The Model Number, Code Version Number and Firmware
Number for your system are displayed on this screen. Make note of these two numbers
when conferring with Axcera on software problems.
Table 3-5: Menu 10 - Main Screen:
This is the default main screen of the transmitter. When the transmitter is in
Standby, the 'OPR' characters appear in the lower right. By pushing the right most
button located under the display, the operator will place the Transmitter in Operate.
When the transmitter is in Operate the 'SBY' characters are displayed, the “OFF” is
replaced with 'ON' and the forward power values are displayed. Pushing the SPL button
will display the two splash screens.
If the ↓ key is activated the display changes to Menu 11, the System Error List Access
Screen. If the ↑ key is activated the display changes to Menu 13, the Transmitter
Configurations Access Screen.
Table 3-6: Menu 11 - Error List Access Screen
This screen of the transmitter shows the current number of errors, displayed in upper,
right of screen (0), and provides operator access to view Menu 20, the error list screens,
by pushing the ENT button. When ENT is pushed, Menu 20, the Error List Display Screen
is displayed. If the ↓ key is pushed the display changes to Menu 12, Table 3-7, the
Transmitter Device Data Access Screen. If the ↑ key is activated the display returns to
Menu 10, the Main Screen.
Table 3-7: Menu 12 - Transmitter Device Data Access Screen
This screen of the transmitter allows access to various parameters of the transmitter
system. This is the entry point to Menu 30, the System Details Screens, by pausing the
ENT button. When the ENT button is pushed, Menu 30 is accessed. Go to Menu 30, Table
3-12 for set up details. Before pushing the ENT button: if the ↓ key is activated the
display changes to Menu 13, Transmitter Configurations Access Screen. If the ↑ key is
activated the display returns to Menu 11, the Error List Access Screen.