User's Manual

User s Guide
2. Slide the wedge tabs on the thin end of the wedge into the bottom tab slots on the ACW-
1xP800.
3. Mark two hole locations 100mm vertically apart and two holes into the wall.
4. Install the screws (not supplied) into the wall, leaving a gap of approximately 3mm
between the screw head and the wall.
5. Align the mounting holes with the screws and mount the ACW-1xP800 onto the screws.
User s Guide
Wall-Mounting
1. Remove the mounting clip from the cradle and re-insert it with the tab pointing up.
Connect the ACW-1xP800 to AC/DC adapter
1. Simply connecting the power adaptor to the back of main phone unit should turn the
phone on and three things will happen:
1. The Power LED indicator is turned on
2. The phone beeps and
3. The start-up graphics begin to play
The phone will then begin searching for a network signal. When a signal is found, the RSSI
icon appears and your phone enters Standby mode. Now the phone is ready for making
calls and receiving calls. (If you want to operate with battery, please turn the battery switch
on the back of main phone unit. Battery must be placed in first for battery operation)
To Power off
To turn your phone off, simply plug off your power adaptor from the back of main unit. If you
are using your battery for operations, then please use the battery power switch on the back
of units.
Mounting Clip in
Cradle
Mounting Holes
Handset Mounting Clip assembly
Handset Mounting Clip for wall-mount.
Mounting ACW-1xP800the onto the screws.
Remove Mounting Clip
from the Cradle (tap down)
Insert Mounting Clip into
the Cradle(tap up)
ON/OFF Switch