Installation Sheet

- 15 -
4.2 Add User Code in Standalone Mode
Warning
Standalone Mode is NOT available after the lock is registered
in App! Please reset the lock to Factory Default Mode rst to
program your lock in Standalone Mode.
Admin Code must be created rst prior to any other programming.
Only one Admin Code is available.
4. Standalone Mode Programming Guide
IndicatorOperation
4.1 Add Admin Code in Standalone Mode
Hold for 3 sec
2 beeps with ashing
green light
Enter 4-8 digit Admin Code
and press
1 beep with green light,
then ashing green light
Enter the Admin Code again
and press
2 beeps with green light
Success All lights o
IndicatorOperation
Hold for 3 sec
2 beeps with ashing
blue light
Enter 4-8 digit Admin Code
and press
2 beeps with green light,
then steady blue light
Enter 4-8 digit User Code
and press
1 beep with green light,
then steady blue light
It is recommended to use U-tec App to program your lock. If
you don’t have a smartphone or don’t want to use the App, you
can use the programming instructions below.