User Guide & Service Manual (Integrated Frame)

USER GUIDE
Troubleshooting - Extended 5
u-line.com
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
FAULT SYSTEM DIAGNOSIS GUIDE
Error Solution 1 Solution 2 Solution 3
No Comm Inspect Customer UI and Data
Cable (if defective replace entire
door)
Zone T Open Inspect zone thermistor
connection. Replace if necessary.
Inspect main control wire harness
for splits or breaks. Repair split or
cut cabling.
Evap T Open Inspect evaporator thermistor
connection. Replace if necessary.
Inspect main control wire harness
for splits or breaks. Repair split or
cut cabling.
Amb Thrm Open Inspect ambient thermistor
connection. Replace if necessary.
Inspect main control wire harness
for splits or breaks. Repair split or
cut cabling.
Zone T Short Inspect thermistor cable for pinch
points or damage. Replace if
necessary.
Inspect wire harness from main
control board for pinch points or
damage. Repair split or pinched
cabling.
Evap T Short Inspect thermistor cable for pinch
points or damage. Replace if
necessary.
Inspect wire harness from main
control board for pinch points or
damage. Repair split or pinched
cabling.
Amb Thrm Short Inspect thermistor cable for pinch
points or damage. Replace if
necessary.
Inspect wire harness from main
control board for pinch points or
damage. Repair split or pinched
cabling.
Temp Hi 6H+ If excessive frost is also noted,
inspect door and door gasket for
proper seal and alignment.
Inspect evaporator fan for proper
operation.
Inspect refrigeration system.
Reference the System Diagnosis
Guide.
Temp Hi 12H+ If excessive frost is also noted,
inspect door and door gasket for
proper seal and alignment.
Inspect evaporator fan for proper
operation.
Inspect refrigeration system.
Reference the System Diagnosis
Guide.
Temp Lo 6H+ Inspect main control for proper
relay operation.
Inspect refrigeration system.
Reference the System Diagnosis
Guide.
Temp Lo 12H+ Inspect main control for proper
relay operation.
Inspect refrigeration system.
Reference the System Diagnosis
Guide.
Door Open 5M Verify door closes properly. Inspect cable arm, verify presence
of magnet, verify proper operation
and movement or arm.
Inspect reed switch wiring.
56