Specification

PART 1 – GENERAL
1.1 Secon Includes
A. Self-adhering Flashing: TYPAR Flashing AT (All-Temperature)
B. Primers
C. Fasteners
1.2 References
A. ASTM Internaonal
1. ASTM D-3330-04 Standard Test Method for Peel or Stripping Strength of adhesive bonds
2. ASTM C-765 Standard pracce for Cold Pliability
3. ASTM D-1970 Standard Specicaon for Self-Adhesion polymer modied bituminous
sheet materials
1.3 Submials:
A. Product Data: Submit manufacturer current technical literature for each type of product
B. Submit copies of test results showing performance characteriscs equaling or exceeding those specied
1.4 Quality Assurance
A. Qualicaons
1. Installer shall have documented successful experience with installaon of TYPAR Flashing
products
2. Installaon shall be in accordance with manufacturer’s installaon guidelines and
recommendaons
PART 2 - PRODUCTS
2.1 Manufacturer
A. PGI, 70 Old Hickory Blvd, Old Hickory, TN 37138, [phone], www.TYPAR.com
2.2 Materials
A. Self-adhering/straight ashing
a. Descripon
i. Face material composion: polypropylene barrier
ii. Face color: gray
iii. Adhesive composion: block copolymer
iv. Thickness: 16mil
v. Release liner: polylm
vi. Dimensions: 4in x 25; 4in x 75; 6in x 75; 9in x 75; 12in x 75
B. Performance characterizaons
a. Low temp pliability (ASTM C-765) PASS
b. Nail sealability (ASTM D-1970) PASS
c. Tensile strength (ASTM D-5034-95) PASS
d. Peel adhesion (ASTM D-3330-04) PASS
2.3 Accessories
A. Primer: Use 3M™ Super77™ or equal
B. Seam tape: TYPAR construcon
C. Fastener: Fastener is dependent on substrate construcon
D. Sealant: Must comply with ASTM C920 elastomeric polymer sealant
PART 3 – EXECUTION
3.1 Examinaon
A. Verify substrate and surface condions are in accordance with the ashing manufacturer’s
recommendaon
NOTE – Flashing manufacturer recommends weather barrier be installed prior to the installaon of the
windows
3.2 Installaon
A. Follow the TYPAR ashing installaon procedures
3.3 Protecon
A. Protect installed ashing from damage during construcon
TYPAR® Flashing AT (All Temperature) Three Part Specs:
SPECIFICATIONS:
TYPAR® FLASHING AT
Three Part Specicaons
MADE IN USA. ICC #ESR-1404 • CCMC #12884-R • CCMC #12892-R
Please visit typar.com for installaon instrucons and warranty informaon
PGI, 70 Old Hickory Blvd., Old Hickory, TN 37138 USA, typar.com