Tools Adjustable Wrench(2) Teflon T 5 & felon Tape X ‘ Groove. Jolnt Puller Yoy \g « Phillips Screwdriver Silicone Sealant Maintenance Your new faucet is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
Parts Diagram / List fif‘”“ 8 -3 @ COoO———14 2728 2% 303N Part Name Connector ©-ring O-ding Waring Sieve Q-ring Spray Head Connector e-fing Hose Guide Stop Valve Spray Head Holder Button Screws O-sing Connector O-ding Wearing Ring Stop Valve Ring Connector Ring O-ding O-ting Connecting Tube Cartridge Base Sleeve Secured Cartridge Cartridge Seal Lock Nut Screws Trim Cap Set Resew Screws Body Connector Base O-inf 55 Threaded Shank Rubber Washer Metal Washer Lock Nut Screws O-inf Copper Tube Copper Tubs Hose Ho
Preparation/Assembly 1. Shut off the water supplies before installation. Remove the current faucet. Clean and dry the surface the new faucet wail be Installed on. 2. Unscrew the lock nut (#40) and remove the metal washer (#39) and rubber washer Note: Do not remove the customer service tag with the model number and phone number. This information will be needed when calling the customer service department. 3.
Installation Instructions 6. Slide the rubber washer (#38) and metal washer onion the threaded shank then screw on the lock nut (#40) and tighten by hand. Do not over tighten. Use a Philips screwdriver to tighten the screws (#41) on the lock nut Note: Assemble in the order listed. See the diagram for a visual. Hint: Have someone hold the body (#33) of the faucet in place while tightening. Hot water Cold Water 7.
Installation Instructions 10. Open the hot and cold shut offs. Check for leaks. leak occurs, refer to step 7 or 8. Hold the hose {#46) in the sink to avoid spraying water out of the sink. 84 Turn on the water and let It run for one minute. This will help clear any debris that may have come ' loose during installation and prevent the system from becoming clogged. Turn off the water and %57 screw the spray head (#60) info the hose Remove the pump (#54) and the nozzle from the & soap dispenser assembly.
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Remove the handle (#50) and firm cap Leaks underneath the handles The lock nut {#28) has come loose. | Tighten the lock nut Replace the tim cap (#30) and handle Remove the handle trim cap and cartridge Chapbook the ceramic disk for dirt and damage.