Tools Adjustable Wrench(2) 5 Teflon Tape « Groove Jolt Puller « Phillips Screwdriver « Silicone Sealant Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a doff cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty. Safety Tips « If you use soldering for the installation of the faucet, the seats, cartridges and washers well have to be removed before using flame.
Parts Diagram / List No.
Preparation/Assembly 1. Shut off water supplies before installation. Remove current faucet, clean and dry the surface the new faucet will be installed on. 2. Unscrew the lock nut {#13) and gasket assembly Please Note: Do not remove the customer service tag with the model number and phone number as this will be helpful if you need assistance in 1s the future. } 3. Apply tension tape fo the threads of the faucet cold & hot water supply tubes in g clockwise direction. 4.
Installation Instructions 7. Attach gasket assembly (#43) and lock nut (#13) from the bottom. Please Note: Assemble in numerical order. Tighten but do not over tighten. Use a fillips screwdriver o tighten the 3-screws (#14) on the lock nut See diagram for visual. Hint: Have someone hold the deck plate in place while tightening. 8. Slip 1/2” coupling nuts onto water supply tubes or use flexible stainless steel supply lines Supply Tue (recommended) — both are sold separately.
Installation Instructions 12. After installing the faucet, remove the spray head (#8) from the spout 3 Note: Hold the spray hose in the sink to avoid water eflj A spraying out of the sink. 13. Then turn on the hot and cold water shut offs. Check % for leaks. If a leak occurs at the supply line connectlonsreferfosteps8orl1. 14. Turn on the faucet for one minute to flush the debris from the faucet. Turn off the faucet and reassemble the pull-down faucet spray head (#8) to hose 15.
Installation Instructions 12. After installing the faucet, remove the spray head (#8) from the spout 3 Note: Hold the spray hose in the sink to avoid water eflj A spraying out of the sink. 13. Then turn on the hot and cold water shut offs. Check % for leaks. If a leak occurs at the supply line connectlonsreferfosteps8orl1. 14. Turn on the faucet for one minute to flush the debris from the faucet. Turn off the faucet and reassemble the pull-down faucet spray head (#8) to hose 15.