Tools Adjustable Wrench(2) Teflon T 5 & felon Tape X ‘ Groove. Jolnt Puller Yoy \g « Phillips Screwdriver Silicone Sealant Maintenance Your new faucet is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
Parts Diagram / List No, Partners 1| Handier 2 | Handle Button 3| Screw 4| McCarty 5| Lock Nut 6 | cartridge 7 | Cartridge Cover 8 Spray Head 9 [ Hose 10| Quick Connect Clip 11] Hose Guide 12| Spout 13| Ring 14| o-ring 15| spout Connector 16| discursiveness 17| Base 18| Body 19| Hose Protector 20| waterway 21| valve 22| Quick Connect Assembly 23| O-ring 24| Deflate 25[ Gasket 26| Threaded Shank 27| Rubber Washer 28| Metal Washer 29[ Lock Nut 30[ resew 31| Hose Protector 32[ Allen Wrench 33[ weight 34| Pump
Preparation/Assembly 1. 2. Unscrew the lock nut (#29) and remove metal washer 3. Apply Teflon tape to the threads of the faucet cold & hot 4. Deck Plate Installation: Shut off the water supplies before installation. Remove the current faucet. Clean and dry the surface the new faucet will be installed on. {#28) and rubber washer Note: Do not remove the customer service tag with the model number and phone number. This information will be needed when calling the customer service department.
Installation Instructions 6. Slide the rubber washer (#27) and metal washer (#28) onto the threaded shank then screw on the lock nut (#29) and tighten by hand. Do not over tighten. Use a Philips screwdriver to tighten the screws (#30) on the lock nut Note: Assemble in the order listed. See the diagram for a visual. Hint: Have someone hold the body (#18) of the faucet in place while tightening. 7.
Installation Instructions 11. Open the hot and cold shut offs. Check for leaks. If a leak occurs, refer to step 9 or 10. Remove the spray 12 head (#8) from the spout Hold the hose (#9) afi in the sink to avoid spraying water out of the sink. Turn on the water and let it run for one minute. = — This will help clear any debris that may have come loose during installation and prevent the system from becoming clogged. Turn off the water and screw the spray head (#8) onto the hose 12.
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Remove the handle (#1) and trim cap Leaks underneath the handle The lock nut (#29) has come loose. Tighten the lock nut Replace the trim cap (#4) and handle Remove the handle fim cap lock nut (#5) and cartridge Check the ceramic disk for dirt and damage. If the cartridge (#6) Is dirty, soak It In warm white vinegar for 4 hours.