Tools Adjustable Wrench(2) S5y Teflon Tape « Groove Jolt Puller « Phillips Screwdriver « Silicone Sealant Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a doff cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty. Safety Tips « If you use soldering for the installation of the faucet, the seats, cartridges and washers well have to be removed before using flame.
Parts Diagram / List Part Name 1 O-Ring 2 O-Ring 3 Wearing Ring 4 Inner Sleeve 5 Threaded Shank é Base 7 O-Ring 8 | Gasket Assembly 9 Lock Nut 10 | Screw 11 | Protective Sleeve 12 | Weight 13 | Handle 14 | Set Screw 15 | Handle Button [Red/Blue) 16 | Trim Cap 17 | Wearing Ring 18 | Body 19 | Spray Head 20 | washer 21 Hose 22 | Hose Guide 23 | Adapter 24 | Lock Nut 25 | Cartridge 26 Waterway Assembly 27 | Stop Valve N N ® Quick Connect Assembly (000emE=0 000 e 29 | Deck Plate 30 | Gasket 31 Pump 32 | Soap Di
Preparation/Assembly . Shut off water supplies before installation. Remove current faucet, clean and dry the sink surface the new faucet will be installed on. . Unscrew the lock nut (#9) and gasket assembly Please Note: Do not remove the customer service tag with the model number and phone number as this will be helpful If you need assistance In the future. . Apply Teflon tape on threads of the faucet cold & hot water supply tubes in a clockwise direction.
Installation Instructions 7. Attach gasket assembly (#8) and lock nut (#9) 10. from the bottom. Please Note: Please assemble in numerical order. Tighten but do not over tighten. Use a fillips screwdriver to tighten the 3-screws (#10) on the lock nut See diagram for visual. . Install the weight (#12) prior to attaching the hose Attach the weight (#12) to the lowest point on the hose (#21) to prevent the hose from twisting. Attach the hose (#21) to the quick connect assembly (#28) on the faucet.
Installation Instructions 19 0 11. After installing the faucet, pull the house (#21) Nl out and remove the spray head (#19) and the S washer {Hint: Hold the hose (#21) in the sink while water Is running to avoid water spraying out of the sink]. Turn on the faucet handier forgone minute to flush the debris from the faucet. Turn off the faucet and re-assemble the washer (#20) and spray head 12. Remove the pump nozzle and pump (#31) from soap dispenser assembly.
Trouble-Shooting If you've followed the instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Leaks underneath handle. Lock nut [#24) has come loose, | Tighten the lock nut Remove cartridge check if ceramic disks Water will not shut off completely.