Tools Needed For Models : 6736146 Adjustable Wrench Q‘s\ 6736147 + Groove Joint Puller 6736148 « Phillips Screwdriver « Silicone Sealant . « Teflon Tape Included { Mariana Single Handle Tub/Shower Faucet Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft, damp cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
Parts Diagram / List 29 No.
Preparation/Assembly 1. Note the installation dimension between shower arm, handle and spout. Fleetness 1036 supreme] o oy 223 mamma] [187mm] Sre47md st o oz am 12 204 81 2. If this is not a thin wall mounting, the protective cover (#4) may be removed from the valve body > 4 o Note: Be sure the valve body is secured to the S support cross board for stability. T 3. Apply Teflon tape on all pipe threads. Install elbow at one end. Connect other end to shower diverted. Secure shower elbow to 2x4 bracing. t 4.
Installation Instructions 5. Turn on the hot and cold water supply lines. Turn on the faucet and let the water from the tub spout run for one minute to flush the debris from the line. If there is a leak, refer to correct section and repeat step. 6. Before install, please slip flange (#3) onto ) the longer end of shower arm 1 Wrap threads of the longer end of shower arm with Teflon tape and install shower arm. Wrap threads of the shorter end of shower arm with Teflon tape and install shower head 7.
Installation Instructions 9. Install escutcheon plate (#7) and secure with screws (#5) and o-ring Make sure valve is in off position. Note: Do not remove the customer service tag with the model number and phone number as this will be helpful if you need assistance in the future. 10. Install volume control handle (#15) with lever straight downward, using Allen key (#28) to secure with set screw 11. Turn on the water to check for leaks.
Installation Instructions 13. 14, 15. Turn on the volume control handle (#15) with lever to the right. Place the temperature control handle (#13) onto the splines (A) with lever straight downward, then rotate the temperature control handle (#13) counter-clockwise until limit stop (B) on temperature control handle (#13) meets the limit stop (C) on the volume control handle (#15) to achieve your maximum desired temperature from the outlet (the highest temperature mandated by your local plumbing code).
Trouble-Shooting If you've followed the instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Acton Lock nut (#17] has come loose or |Tighten the lock nut Clean Leaks underneath handle |o-ring on cartridge (#16] Is dirty o) of replace o-ring on twisted. cartridge Ea move the handles [#13 and #15) and the cartridge Verify the . Rubber valve seat at the base of | rubber vole seats seated properly Water will not shut off completely.