Installation Instructions

ManualsBrandsTurn of the Century ManualsCeiling Fan Lights4-Light Antique Brass Ceiling Fan Light Kit with Antique Brass Shades

Turn of the Century

121017

355-3154 / 355-3155 / 355-3156

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless

additional support is provided for the fan.

1. Unscrew the three screws from the switch box, remove the

switch box cover and disconnect the wire nuts. (See Fig. 1)

2. Push the center plug from inside the switch box cover to

remove the center plug. (See Fig. 1)

Note: Save the center plug should you choose to remove

the light fixture in the future.

3. Feed the two wires from the fan light kit through the center

hole in the switch box cover, and thread the wires through

the washer and hex nut, then secure switch box cover onto

the fan light kit with a hex nut and washer. (See Fig. 2)

4. Connect wires by using the wire nuts: (See Fig. 2)

---The black (hot) wire from fan light kit to the black (hot)

wire from the fan.

---The white (neutral) wire from fan light kit to the white

(neutral) wire from the fan.

---Carefully put wires back into the switch box.

5. Restore the switch box cover back to the switch box by

using the three screws. (See Fig. 2)

6. Adjust the shades to a desired position by using the swivels. (See Fig. 2)

7. Install bulbs (included). See relamping label at socket area or packaging for maximum

allowed wattage. (See Fig. 2)

8. Turn on the electric circuit.

Motor

Switch Box

Hex Nut

Screw

Switch Box Cover

Nipple

Wire Nut

Washer

Center Plug

Fan Light

Pull Chain

Swivel

----This FAN LIGHT can be installed in one of two ways.

----This fan light is not compatiable with ceiling fans

containing an integrated light kit.

Fig.1.

Switch Box Cover

Screw

Switch Box

Fig.2.

Wire Nut

Installing the fan light on fans with Non-Removable

switch box:

Bulb Type R Max.40W

(included)

Shade

WARNING:

As per EPACT 2005 requirements, this fan light has a built-in current

limiting device to conserve energy. The fan light will not operate if the

combined wattage of the installed bulbs exceeds 190 Watts. If the fan

light shuts off shortly after being switched on, it may be due to

excessive current demand. You should replace the light bulbs with

lower wattage bulbs.

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS 355-3154 / 355-3155 / 355-3156 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless additional support is provided for the fan.
PAGE 2
Installing the fan light kit on a removable switch box: 1. Unscrew the three screws from the fan, remove the switch box and disconnect the terminals. (See Fig. 3) 2. Push the center plug from inside the switch box to remove the center plug. (See Fig. 3) Save the center plug should you choose to remove the light fixture in the future. 3.