Installation Guide

ManualsBrandsTuffBilt ManualsDeck & Porch RailingsHandiRail 3.57 in. x 63.25 in. x 3.10 ft. Aged Bronze 4-Step Aluminum Rail Kit (Unassembled)

INSTALLATION INSTRUCTIONS

HandiRail

™

Aluminum Rail Kit

34115903

Read all instructions prior to installing product.

Refer to manufacturers safety instructions when operating any tools.

To register your product, please visit:

www.tuffbilt.com

Tape Measure

Level

Drill

Safety Glasses

Masonry Drill Bit

Phillips Screwdriver

¼" x 3¼" Zinc Plated

Masonry Fasteners

⁄2"-13TPI x 12" Zinc Plated

Threaded Rods

⁄8"x5" External

Hex Head Lag Screws

TOOLS/MATERIALS NEEDED: FASTENERS NEEDED:

FOR CONCRETE:

FOR WOOD:

WARNING:

• Improper installation of this product can result in personal injury. Always wear safety goggles when

cutting, drilling and assembling the product.

• Incorrect installation may cause harm to the product or individual.

• Not pool code approved.

NOTICE:

• DO NOT attempt to assemble the kit if parts are missing or damaged.

• DO NOT return the product to the store. For assistance or replacement parts call: 1-877-279-4496.

Summary of content (4 pages)

PAGE 1
34115903 HandiRail™ Aluminum Rail Kit INSTALLATION INSTRUCTIONS WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. • Not pool code approved. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store. For assistance or replacement parts call: 1-877-279-4496.
PAGE 2
Railing Components: QTY. Description 1 Top Rail 1 Mid Rail 1 Upper Post 1 Lower Post 2 Base Trims 8 #8 x ¾" Screws 4 Base Trim Fasteners Top Rail Lower Post Base Trims Upper Post Mid Rail Square Drive Drill Bit 1 Screws Base Trim Fasteners Attach Mid Rail to Posts: a. Insert the ends of the curved mid rail into the holes of each post making sure holes in rail align with holes in post (Fig. 1).
PAGE 3
2 Attach Top Rail With Curved Ends to Posts: a. Insert the ends of the top rail on top of each post making sure holes in rail align with holes in post (Fig. 3). Fig. 3 Top Rail b. Drive #8 x ¾" self-tapping screws into post holes and through rail holes (one on each side). Do not tighten completely (Fig. 4). Do for both top and bottom posts. Screw Hole Post Fig. 4 Top Rail Post 3 Attach Section to Stair: Fig. 5 a. Position your assembled panel on steps to location as desired (Fig. 5). b.
PAGE 4
3 Option 2 (Concrete Only): Fig. 7 Using the 1⁄2" threaded hole under the base plates: • Determine center of each post. Do this by marking holes through the mounting plates of posts (upper and lower) onto the mounting surface (Fig. 6). Center • Remove the rail section and posts. Then, from the those marks just made, draw an “X” and where the lines cross is the center (Fig. 7). • Drill a hole at the center marks with a ½" drill bit 33⁄4" deep. Fig.