ASSEMBLY INSTRUCTION PLEASE READ BEFORE ASSEMBLING! Tip #1: Make sure you've taken all the pieces and hardware out of its packaging before discarding the box. Assembly on top of flattened box/ blanket is recommended. Tip #2: Using page 2 and/or page 3 of instruction manual make sure all pieces and hardware are accounted for. Tip #3: Note position of all hole son each panel during assembly.
HARDWARE IDENTIFICATION A Bm L29 PCs ay DD Glue: For securing please apply to wood 1 wv dowel first before inserting into panel pc PAGE 3 OF 11
ASSEMBLY INSTRUCTION STEPPE To adjust the door In or out,loosen this screw and push the door further In or push further out then re tighten screws. To adjust the door vertically, loosen the top and bottom screws, push the door up or down as necessary, then re tighten screws. To adjust the door left/right, tum this screw clockwise to move this comer of the door toward the frame, or counterclockwise to move door away from the frame.
ANTI-TIPPING STRAP INSTRUCTION HARDWARE (INCLUDED) : TOOLS NEEDED ( NOT INCLUDED): DRILL & DRILL BIT Ke LIGHT HAMMER CEs DRYWALL ANCHOR $8X40 X 1PC METAL BRACKETS 12X12X1 X PCS DRYWALL SCREW $5%40 X 1PC mae STRAP 197X5X1 X 1PC Ooo FLATHEAD SCREW ®4X25 X 1PC Note: Hardware included only compatible with standard drywall. STEP 1 1.Find spot on wall 1” below top of item. 2.Using a drill bit slightly thinner than anchor , drill hole into drywall. STEP 2 1.Use a light hammer to tap anchor into hole. 2.