Manualshelf

Spec Series Manual

ManualsBrandsTrue ManualsCommercial EquipmentSTA2H-4HG Spec Series Two-Section Reach-In Heated Holding Cabinet with 56 Cu. Ft. Capacity, External Temperature Display, and Glass Half Swing-Doors
12345678910
4
The following procedure is recommended for unpackaging the unit:
A. Remove the outer packaging, (cardboard and bubbles or styrofoam corners and clear plastic). Inspect for concealed
damage. Again, immediately file a claim with the freight carrier if there is damage.
B. Move your unit as close to the final location as possible before removing the wooden skid.
NOTE
Keys for units with door locks are located in warranty packets.
UNPACKAGING
REMOTE UNITS (This section applies to remotes only!)
• Remote cabinets must be ordered as remote. We do not recommend converting for a standard self contained
to remote system.
• All remote cabinets must be hard wired.
• No castors available.
• All remote cabinets come standard using 404A refrigerant.
• All remote units come standard with expansion valve, liquid line solenoid, heated condensate pan, and defrost
timer when applicable.
• Contact TRUE Technical Service for BTU requirements.
• No wiring necessary between cabinet and condensing unit.
• All remote condensing units purchased from TRUE are 208/230 volts single phase.
If you have any questions regarding this section, please call TRUE at 1-(800)-325-6152.
The following procedure is for locking and unlock unit:
A. Insert the key and turn.
B. Remove the key.
LOCK AND KEYS
Insert key