Datasheet

ManualsBrandsTRU COMPONENTS ManualsResistorsMetal film resistor 24 Ω Axial lead 1 W TC-MOR01SJ0240A10203 1 pc(s)

1. Scope:

This specification for approval relates to Metal Oxide Film Fixed Resistors

2. Type designation:

The type designation shall be in the following form :

(Ex.) MOR 1W-S J

˄˃Ө

Type Power Rating Resistance Nominal

Resistance

3. Ratings:

Ratings shall be shown in the table 1.

Table 1

Type

Rated Power

Max. Working Voltage

Max. Overload Voltage

Dielectric Withstanding Voltage

Rated Ambient Temp.

Operating Temp.Range

Resistance Tolerance

Resistance Range

3.1 Power rating:

Resistors shall have a power rating based on continuous full load operation at an

ambient temperature of 70 к. For temperature in excess of 70 к , the load shall be

derated as shown in the figure 1.

3.2 Voltage rating:

Resistors shall have a rated direct-current (DC) continuous working voltage or an approximate

sine-wave root-mean-square (RMS) alternating-current (AC) continuous working voltage at commercial-

line frequency and waveform curresponding to the power rating , as determined from the

following formula :

RCWV =

ЅP x R

Were : RCWV = Rated DC or RMS AC continuous working voltage at commercial-line frequency and

waveform (volt)

P = Power Rating (watt)

R = Nominal Resistance (ohm)

70 к

-55к --- +130к

± 5 %

1 ~ 50K

350 V

600 V

350 V

MOR

1W at 70к

Tolerance

All part numbers in the coding below start with "TC-" and end with "203"

Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau

Datasheet

V1_0717_01_en

Summary of content (10 pages)

PAGE 1
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau Datasheet V1_0717_01_en 1. Scope: This specification for approval relates to Metal Oxide Film Fixed Resistors 2. Type designation: The type designation shall be in the following form : (Ex.) MOR 1W-S J ˄˃Ө Type Power Rating Resistance Nominal Resistance Tolerance All part numbers in the coding below start with "TC-" and end with "203" 3. Ratings: Ratings shall be shown in the table 1.
PAGE 2
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau Datasheet V1_0717_01_en Metal Oxide Film Fixed Resistors In no case shall the rated DC or RMS AC continuous working voltage be greater than the applicable maximum value Figure 1. 3.3 Nominal resistance : Effective figures of nominal resistance shall be in accordance with E-96 series, and resistance tolerance shall be shown by table 1. 4. Construction : No.
PAGE 3
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau Datasheet V1_0717_01_en Metal Oxide Film Fixed Resistors 5. Characteristics : Characteristics Test Methods ( JIS C 5201-1 ) Limits DC. resistance Must be within the specified tolerance Insulation resistance Insulation resistance is 20 M Min Dielectric withstanding voltage No evidence of flashover mechanical damage, arcing or insulation break down Resis.Range Temperature coefficient 0.1 ~ 12 12.1 ~ 100K 101K ~ 1M 1.
PAGE 4
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau Datasheet V1_0717_01_en Metal Oxide Film Fixed Resistors 5. Characteristics : Characteristics Short time overload Terminal strength Solderability Limits Test Methods ( JIS C 5201-1 ) Resistance change rate is 4.13 Permanent resistance change after the ± (2% + 0.05Ө) Max. with no application of a potential of 2.5 times RCWV evidence of mechanical damage for 5 seconds Direct load : Resistance to a 2.
PAGE 5
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau Datasheet V1_0717_01_en Metal Oxide Film Fixed Resistors Characteristics Temperature cycling Load life in humidity Load life Test Methods ( JIS C 5201-1 ) Limits Resistance change rate is ± (2% + 0.05Ө) Max.
PAGE 6
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau Datasheet V1_0717_01_en Metal Oxide Film Fixed Resistors 6. Dimension : Unit : mm Type Power Rating D (Max.) L (Max.) d ± 0.05 H±3 MOR 1W-S 3.5 mm 10.0 mm 0.54 mm 28 mm Painting method: Welding point, terminal and lead wire, is permissible to be exposed without the outer coated cover. The extent should be within 1/2 of the are angle. 7. Marking : 7.
PAGE 7
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau Datasheet V1_0717_01_en Metal Oxide Film Fixed Resistors 8. Packing specification : 8.1 Taping dimension : Dimensions (mm) Type Style MOR-100-S PT-52 O P L1-L2 T Z R t S 52 ± 1 5 ± 0.3 1 Max. 6±1 1 Max. 0 4±1 0.5 Max. 8.2 Tape in box packing : Bandoliers may also be contained in a cardboard box ("Ammopack") Dimension (mm) Type Style MOR-100-S PT-52 L (C) W (A) H (B) Quantity Per Box ±5 ±5 ±5 (pcs.
PAGE 8
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau Datasheet V1_0717_01_en Metal Oxide Film Fixed Resistors 8.3 Tape on reel packing : Dimension (mm) : Type Style Across Flange (A) Quantity Per Reel MOR-100-S PT-52 73 ± 2 2,500 pcs.
PAGE 9
Distributed by Conrad Electronic SE • Klaus-Conrad-Str.
PAGE 10
Distributed by Conrad Electronic SE • Klaus-Conrad-Str. 1 • D-92240 Hirschau Datasheet V1_0717_01_en Metal Oxide Film Fixed Resistors Environment Related Substance This product complies to EU RoHS directive, EU PAHs directive, EU PFOS directive and Halogen free. Ozone layer depleting substances. Ozone depleting substances are not used in our manufacturing process of this product.