User manual

MAINTENANCE AND REPAIR INSTRUCTIONS

Trimming Line

Line Loading Hole

Eyelet

Fig. 42

Line Locking Hole

5. Insert the line into the locking hole (Fig. 43). Do not

push the line more than a 1/2 inch (12.7 mm) into the

line locking hole. The line will form a small loop

(Fig. 43) when it is inserted correctly.

Fig. 43

6. Pull the line from the outer spool until the line is tight

against the inner reel (Fig. 44).

Fig. 44

Fig. 45

7. Repeat procedures 4-6 with the second piece of line.

8. Hold the outer spool. Wind the inner reel

counterclockwise until approximately four (4) inches

(102 mm) of line remain (Fig. 45).

NOTE: Do not wind the inner reel before installing the

second piece of line.

9. If winding the line becomes difficult or if the line

jams, pull the ends of the line from the spool

(Fig. 46). Continue winding the inner reel

counterclockwise until approximately 6 inches of line

is left.

Fig. 46

INSTALLING A PRE-WOUND REEL

1. Turn the bump knob counterclockwise and remove

the bump knob, spring and foam seal (Fig. 47).

Bump Knob

Foam Seal

Spring

Inner Reel

Fig. 47

2. Pull the old inner reel with existing line from the outer

spool.

3. Insert the ends of the prewound inner reel line into

the outer spool eyelets (Fig. 48). Push the new inner

reel, arrow side up, into the outer spool.