User's Manual

FUEL FILTER

1. Remove air box cover and air filter as shown in Fig. 31.

Disconnect fuel hose (A) from carburetor fitting (Fig. 32).

3. Pull fuel filter (C) out of tank with a bent wire (D) or

long needle nosed pliers. Disconnect filter and

discard (Fig. 32).

NOTE: Do not pull hose completely out of tank.

4. Install a new fuel filter on hose and pull hose/filter

assembly back into tank so filter is positioned in front

right corner.

5. Reconnect fuel hose (A) to carburetor fitting (B) (Fig. 32).

Replace air filter and air box cover.

6. Fill tank with fresh fuel / oil mixture. See Oil and Fuel

Information. Install fuel cap.

MAINTENANCE AND REPAIR INSTRUCTIONS

AIR FILTER

1. Remove the top cover (A) by loosening the cover

retaining screws. Cover will lift off (Fig. 31).

2. Clean air filter. Wash filter in clean, warm, soapy

water. Rinse in clear, cool water. Air dry completely.

NOTE: It is advisable to have a supply of spare filters.

3. Install air filter. Install engine / air filter cover. Make

sure cover fits properly. Tighten the cover retaining

screws securely.

Never operate saw

without the air filter.

Dust and dirt wil be drawn into engine and

damage it. Keep the air filter clean.

CAUTION:

o avoid serious

personal injury,

always turn your unit off and allow it to cool

before you clean or service it.

WARNING:

Never operate saw

without the fuel filter.

The fuel filter should be replaced after each 20

hours of use. Drain fuel tank before changing.

CAUTION:

Fig. 31

Fig. 32