SDS

ManualsBrandsTroy-Bilt ManualsChainsaws18 in. 42 cc 2-Cycle Lightweight Gas Chainsaw with Automatic Chain Oiler

MTD SYNTHETIC 2-CYCLE ENGINE OIL

Page 1 of 8

Safety Data Sheet

Conforms to HCS 2012 (29 CFR 1910.1200)

Section 1. Identification

Product identifier

Product Name: MTD SYNTHETIC 2-CYCLE ENGINE OIL

Other names: F-700

Part/Product Number(s): 734-04635, 737-05008, 737-05016, 737-05016-1, R70110

Material Use: 2-cycle engine fuel additive

Uses advised against: Not for use in non-2-cycle engines

Manufacturer: Omni Specialty Packaging, LLC

10399 Hwy 1 South

Shreveport, LA 71115

1-318-524-1100

Issuing date: May 21, 2015

Revision date: October 8, 2015

Revision number: 001

Company contact: OMNI EHS Department: E-Mail: sds@osp.cc; Contact phone: 318-524-1100

(Monday-Friday, 8:00 AM – 4:00 PM, CST)

In case of emergency: CHEMTREC: Within USA and Canada: 1 (800) 424-9300 (24/7)

CHEMTREC: Outside USA and Canada: +1 703-527-3887 (24/7)

Section 2. Hazards Identification

OSHA/HCS Status: This product is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR

1910.1200).

Classification of the Substance or Mixture: Flammable Liquids – Category 4

GHS Label Elements

Hazard pictograms: None

Signal word: Warning

Appearance: Blue-green Physical State: Liquid Odor: Petroleum distillates

Physical Hazard statement: Combustible Liquid.

Health Hazard statement: May cause drowsiness or dizziness.

Precautionary statements

General: Read label before use. Keep out of reach of children. If medical advice is needed, have product

container or label at hand.

Prevention: Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Avoid breathing

mist/vapors/spray. Use only outdoors or in a well ventilated area. Keep container tightly closed

Wear protective gloves/protective clothing/eye protection/face protection

Response: In case of fire: Use media specified in Section 4 to extinguish.

Storage: Store in a well-ventilated place. Keep cool.

Disposal: Dispose of contents/container to an approved waste disposal plant.

Hazards not otherwise classified (HNOC): Defatting to the skin. Hot motor oil may cause potentially serious burns.

Summary of content (8 pages)

PAGE 1
MTD SYNTHETIC 2-CYCLE ENGINE OIL Safety Data Sheet Conforms to HCS 2012 (29 CFR 1910.1200) Section 1.
PAGE 2
MTD SYNTHETIC 2-CYCLE ENGINE OIL Other information: October 8, 2015 Harmful to aquatic life with long lasting effects. PROLONGED OR REPEATED CONTACT MAY DRY SKIN AND CAUSE IRRITATION. May cause slight eye irritation. May cause drowsiness or dizziness. NOTE: Product diluted with gasoline must be handled with the same precautions used for gasoline. Before mixing, the Safety Data Sheet for gasoline should be consulted for any precautionary measures necessary. Section 3.
PAGE 3
MTD SYNTHETIC 2-CYCLE ENGINE OIL October 8, 2015 Inhalation: Not expected to be harmful if inhaled. Contains petroleum-based mineral oil. May cause respiratory irritation or other pulmonary effects following prolonged or repeated inhalation of oil mist at airborne levels above the recommended oil mist exposure limit. Symptoms of respiratory irritation may include coughing and difficult breathing. Ingestion: Not expected to be harmful if swallowed. Note to physician: Treat symptomatically. Section 5.
PAGE 4
MTD SYNTHETIC 2-CYCLE ENGINE OIL October 8, 2015 local regulations. Dispose of via a licensed waste disposal contractor. NOTE: If RQ (Reportable Quantity) is exceeded or if spills enter a body of water, report immediately to the USEPA’s National Response Center at (800) 424-8802. Check with your local and state regulators regarding their reporting requirements. Section 7.
PAGE 5
MTD SYNTHETIC 2-CYCLE ENGINE OIL October 8, 2015 Hand protection: Wear protective gloves if prolonged or repeated contact is likely. Wear chemical resistant gloves. Recommended: Nitrile gloves. Consult your supervisor or Standard Operating Procedure (SOP) for special handling instructions. Body protection: No protective equipment is needed under normal use conditions.
PAGE 6
MTD SYNTHETIC 2-CYCLE ENGINE OIL Acute Toxicity Lubricant Base Oil (Petroleum) Highly refined mineral oils (C15C50) Mixture - Typical Distillates (Petroleum), Hydrotreated, light, Naphtha 64742-47-8 October 8, 2015 Oral LD50 >2000 mg/Kg (rat) Dermal LD50 >2000 mg/Kg (rabbit) Inhalation LC50 >2.18 mg/L (rat) 4h (mist) >5000 mg/Kg (rat) >5000 mg/Kg (rabbit) >2000 mg/L (rat) 8h (vapor) Aspiration hazard: Not expected to be an aspiration hazard.
PAGE 7
MTD SYNTHETIC 2-CYCLE ENGINE OIL October 8, 2015 Other adverse effects: No known significant effects or critical hazards. Other ecological information: Spills may form a film on water surfaces causing physical damage to organisms. Oxygen transfer could also be impaired. Section 13. Disposal Considerations Disposal recommendations based on material supplied. Waste treatment methods: This material, as supplied, is not a hazardous waste according to Federal regulations (40 CFR 261).
PAGE 8
MTD SYNTHETIC 2-CYCLE ENGINE OIL State Regulations Massachusetts: New Jersey: Pennsylvania: California Proposition 65: Canada WHMIS Hazard Class: October 8, 2015 None of the components are at or above regulated thresholds. Petroleum Oil (Motor Oil) None of the components are at or above regulated thresholds. WARNING: This product contains a chemical known to the State of California to cause cancer. None.