Trimmer/Mower Owner's Manual

Section

Maintenance/Repairs

NOTE: All references to left, right,

front and rear of the machine are

determined by standing behind the

handlebars and facing the direction

of forward travel.

Before inspecting, cleaning or

servicing the machine, shut off

engine, disconnect spark plug

wire, and make sure that all

moving parts have come to a

complete stop. Remove ignition

key on electric start models.

Failure to follow these instruc-

tions can result in personal in-

jury or property damage.

WARNING

REQUIRED MAINTENANCE SCHEDULE

REQUIRED MAINTENANCE BEFORE EVERY EVERY EVERY AS

EACH 5 25 100 NOTED

USE HOURS HOURS HOURS

CHECK ENGINE OIL LEVEL •

CHECK TRIMMER/MOWER LINES • 1

CHECK TRIMMER HEAD ENGAGEMENT •

ENGINE/MACHINE CLEANING • 3

CHECK NUTS AND BOLTS •

CHANGE ENGINE OIL • 2

SERVICE AIR FILTER SYSTEM • 5

CLEAN OUT BELT COVER •

GENERAL LUBRICATION •

INSPECT DRIVE BELT •

CLEAN ENGINE FOAM DEBRIS FILTER • 4

CHECK WEAR CUP • 6

NOTE 1 – New line replacement is suggested when old line is 50% or less of original length.

NOTE 2 – Change oil after first two hours of new operation; thereafter every 25 hours.

NOTE 3 – Clean daily if used in extremely dusty or dirty conditions.

NOTE 4 – Clean before using machine, and at each fuel refill.

NOTE 5 – Service more often if used in extremely dusty or dirty conditions.

NOTE 6 – Replace when severe gouges exist on bottom surface.

Chart 5-1