Installation Guide

ManualsBrandsTroposAir ManualsCeiling FansTornado 72 in. Indoor/Outdoor Pure White Ceiling Fan

3ID72

Tornado 72 & Tornado

This instruction contains 5 pages:

Page 1: Foreword

Page 2: Unpack and inspect parts contained

Page 3: Notes before installation and Hanging system installation

Page 4: Wire connection, Canopy installation and Blade installation

Page 5: Pull Chain Knob installation

WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.

Toll Free: 1-855-676-7247

6.4 KGS.

14.1 LBS.

Net weight

3ID56

Summary of content (6 pages)

PAGE 1
Tornado 72 & Tornado 3ID72 3ID56 This instruction contains 5 pages: Page 1: Foreword Page 2: Unpack and inspect parts contained Page 3: Notes before installation and Hanging system installation Page 4: Wire connection, Canopy installation and Blade installation Page 5: Pull Chain Knob installation Net weight 6.4 KGS. Toll Free: 1-855-676-7247 14.1 LBS. WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.
PAGE 2
READ AND SAVE THESE INSTRUCTIONS WARNING : TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, PLEASE OBSERVE THE FOLLOWING : 1]. To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning. 2]. To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring. All electrical connections must be made in accordance with local codes, ordinances and/or the National Electric Code.
PAGE 3
Unpack and inspect fan carefully to be certain all contents are included.
PAGE 4
WARNING: blades should be at least 10 feet from floor Note 1: Note 2: Turn off power at breaker box to avoid possible electrical shock. Use metal outlet box suitable for fan support. Outlet box must support 35 lbs min. OFF OFF OFF 1. HANGING SYSTEM INSTALLATION 1A. Installing mounting bracket to ceiling outlet box Install mounting bracket to outlet box in ceiling by using screws included with the outlet box and washers from the hardware bag. Outlet Box Mounting Bracket 1B.
PAGE 5
2. WIRE CONNECTION Making electrical wire connection Follow diagram below and make sure that all exposed wires are secured inside wire nuts or terminal block. Note : Wires from house may vary in color and may not include ground wire ( green ).
PAGE 6
4B. Attach blades to fan assembly by using blade screws removed from step 4A. (* Repeat until all 3 blades are installed firmly.) Blade Screw(2) Blade Paper Spacer Fan Assembly 5. PULL CHAIN KNOB INSTALLATION Connect Pull Chain Knob provided from hardware bag to the pull chain from switch housing. Switch Housing Pull Chain Knob 6.Turn on power at breaker box for operation.