Instructions / Assembly

ManualsBrandsTroposAir ManualsCeiling FansMcCoy 52 in. Pure White Ceiling Fan

Owner’s Manual

3TP52

WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.

5.1 KGS.

11.23 LBS.

Net weight

McCoy

Toll Free: 1-855-676-7247

This instruction contains 6 pages:

Page 1: Foreword

Page 2: Unpack and inspect parts contained

Page 3: Notes before installation and

Page 4:

Page 5: Blade installation /Canopy installation

Hanging system installation

Wire connection

Page 6: Remote

Summary of content (7 pages)

PAGE 1
Owner’s Manual McCoy 3TP52 This instruction contains 6 pages: Page 1: Foreword Page 2: Unpack and inspect parts contained Page 3: Notes before installation and Hanging system installation Page 4: Wire connection Page 5: Blade installation /Canopy installation Page 6: Remote Net weight 5.1 KGS. Toll Free: 1-855-676-7247 11.23 LBS. WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.
PAGE 2
READ AND SAVE THESE INSTRUCTIONS WARNING : TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, PLEASE OBSERVE THE FOLLOWING : 1 ] . To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning. Two people recommended for fan installation. 2]. To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring.
PAGE 3
Unpack and inspect fan carefully to be certain all contents are included.
PAGE 4
WARNING: blades should be at least 7 feet from floor Note 1: Note 2: Turn off power at breaker box to avoid possible electrical shock. Use metal outlet box suitable for fan support. Outlet box must support 35 lbs min. OFF OFF OFF 1. HANGING SYSTEM INSTALLATION 1A.Installing mounting bracket to ceiling outlet box Install mounting bracket to outlet box in ceiling by using screws included Outlet Box with the outlet box and washers from the hardware bag. Mounting Bracket 1B.
PAGE 5
2. WIRE CONNECTION 2A. Making electrical wire connection. Follow diagram below and make sure that all exposed wires are secured inside wire nuts. Note: Wires from house may vary in color and may not include ground wire (green). After wiring is completed, collect wires neatly inside hanging base.
PAGE 6
2C. Insert receiver into mounting bracket NOTE: Do not sq u eeze all the wires while inserting the receiver into the mounting bracket. 3. CANOPY INSTALLATION Note: Two screws are pre-installed on mounting bracket for canopy installation. 1 Push up canopy until two screws pre-screwed on mounting bracket are engaged with two key holes on canopy. 2 Rotate canopy slightly until two pre-installed screw heads are engaged in the narrow end of key holes. 3 Tighten both screws.
PAGE 7
5. REMOTE NOTE： Make sure transmitter and receiver have the same code for fan operation. LOW:Fan low speed MED:Fan middle speed HI:Fan high speed MED HI LO W O FF OFF: For SETTING / Fan speed : Button for ON/OFF Light NOTE : This fan has no light, so please disregard this light function. 6. Turn on the power - your fan is ready for operation.