Instructions / Assembly

Installation & Assembly Instructions
Please contact Customer Service with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 1
Read all instructions completely before installing. Should you have any questions about your
installation, please call Customer Service at 440-248-5480
Review Carton Contents: (1 Box Makes Up This Kit):
• 2 Pcs. LocBoard Pegboard 18" x 36" (BKit= Blue, BKKit=Black, CK=White, G=Gray)
• 28 Pcs. Assortment of LocHook® Pegboard Hooks
• 2 pcs. Small Bin (205) 3-5/8” L x 3-7/8” W x 1-3/4” H
• 1 pk. Wall Mounting Hardware Packet
• Boards can be positioned side by side or in separate location in vertical or horizontal mounting
positions.
• Pegboards fasten directly to concrete, solid wood and hollow wall structures without the use of
furring strips.
• Pegboards are designed with internal mounting flanges that keep mounting hardware hidden
from sight and add to the board’s structural integrity and holding power.
• If installing to bare studs you will need to install wood headers before completing installation.
Tools needed for Installation (not supplied with kit)
Level, marker, 7/32” standard or masonry drill bit, 7/64” drill bit for wood studs, #2 Phillips head
screwdriver, power drill.
For drywall, hollow concrete wall installation: Use (12 each) plastic drywall anchors and #8 Phillips
head wood screws (SUPPLIED WITH THIS SYSTEM). If installing to bare studs you will need to install
wood headers before completing installation using wood screws only. NOTE: Always install one board at
a time.
1. (IMPORTANT!) Select wall location for your LocBoards and the desired vertical or horizontal
mounting pattern you wish to mount in. When selecting a location for mounting always make
sure that mounting locations do not fall in line with, are adjacent to or interfere with any
internal or external electrical wiring, wall mounted or built-in electrical appliances, heaters, gas
lines, ductwork or plumbing inside of wall, or are located on the opposite side of any wall
surface from where you are mounting. If you are unsure, please consult a professional before
proceeding with installation.
2. There are three screw holes in each mounting flange on the back of your LocBoard that are
accessible through the square holes on the front (see images on back).
3. Place one LocBoard with mounting flanges flat against wall surface, while using a level to make
sure your board is straight and squared. Mark the centers of all 6 screw holes onto your wall
surface. Note: Installation for first board should be completed before marking mounting holes
for the second board.
4. Pre-drill holes for #8 wall anchors marked in Step 3 using 7/32" standard or masonry drill bit
depending on wall surface. If you hit a wood stud stop drilling and using a 7/64” drill bit create a
pilot hole for the wood screw, Note: avoid over-drilling holes. (Plastic wall anchors should fit
snug.)
LB18-CK, BKit, BKKit, GKit Instruction Sheet – (2) 18” x 36” LocBoard® Pegboards, 28
Hooks, 2 Bins