Installation Guide

ManualsBrandsTriple Clear ManualsKitchenPoint of Use Under-Sink Water Filtration System Kit with a 5 in. Filter

REPLACING THE FILTER

1. Close inlet isolation valve and open cold water faucet to relieve

pressure. Once pressure is relieved close cold water faucet.

2. Close outlet isolation valve.

3. Remove inlet and outlet connections on Triple Clear Force

Field Filter by pushing in collet and pulling tubing straight out of

connections.

4. Remove Triple Clear Force Field Filter from mounting bracket and

discard appropriately.

5. Install new Triple Clear Force Field Filter into mounting bracket.

6. Insert inlet and outlet tubing in the appropriate filter connections.

Tubing should insert 3/4 to 7/8” into connections.

7. Open inlet isolation valve slowly, inspecting tubing and

connections for any leaks.

8. Open outlet isolation valve slowly, inspecting tubing and

connections for any leaks.

NOTE: IN THE EVENT OF LEAKAGE, TURN OFF WATER SUPPLY

AND TAKE APPROPRIATE ACTION TO RECTIFY.

9. Open faucet to purge any trapped air from the system, confirm

proper operation, and allow filter to flush prior to use. A minimum of

XXX gallons is recommended to flush the filter.

For more information or questions, please contact your authorized

installer.

Installation and

Operating Instructions

Triple Clear Force Field Filter

TC-POU-FFC10

and

TC-POU-FFC5

Summary of content (4 pages)

PAGE 1
REPLACING THE FILTER 1. Close inlet isolation valve and open cold water faucet to relieve pressure. Once pressure is relieved close cold water faucet. Installation and Operating Instructions 2. Close outlet isolation valve. 3. Remove inlet and outlet connections on Triple Clear Force Field Filter by pushing in collet and pulling tubing straight out of connections. Triple Clear Force Field FilterTM 4. Remove Triple Clear Force Field Filter from mounting bracket and discard appropriately. 5.
PAGE 2
SAFETY INFORMATION Read all safety information and instructions prior to installation of the Triple Clear Force Field Filter. • The Triple Clear Force Field Filter is intended for use in filtering potable water in homes. The system is typically installed at the point of use, and must be installed according to these instructions. • This filter is intended to be used in a vertical arrangement and should be in a location that will prevent it from being struck by other items.
PAGE 3
INSTALLING THE MOUNTING BRACKET: 1. Select a location for the mounting bracket. For ease of filter replacement select a location that offers easy access. 2. Using the level place the mounting bracket level against the wall and mark the four screw holes. 5. Insert appropriate opaque tubing into the inlet side of the Triple Clear Force Field Filter. Tubing should insert 3/4 to 7/8” into the inlet side. 6. Insert other opaque tubing into the outlet side of the Triple Clear Force Field Filter.
PAGE 4
INSTALLING THE FILTER: 1. (a)Turn off the cold water supply, (b)open cold water faucet and (c)cut into existing 3/8” supply lines. Once supply line has been cut, (d)close cold water faucet. 3. Insert one piece of the opaque supply tubing into the other side of each isolation valve. Tubing should insert 3/4 to 7/8” into isolation valve socket. NOTE: VALVES SHOULD BE IN THE CLOSED POSITION DURING INSTALLATION 2.