User's Manual

Page 42
E Series Data Radio – User Manual
© Copyright 2005 Trio DataCom Pty. Ltd.
Programmer
Main Window
When first started the programmer is in file mode as indicated by
the mode field at the bottom right of the panel shown below. In this
mode it is possible to open a previously saved configuration file, or
configure various programming options and save the configuration
to a file.
Note: Modulation type is not available in this mode.
To commence programming a unit (radio remote or base station)
a session must first be established by using the “READ” function.
This function reads the current configuration from the unit and
displays it in the main window. The “mode” displays changes to
local or remote depending on the type of session selected at the
read function. Several options in the main window may be blanked
out until a session has been established with a unit.
Note: Changing any item on the menu will in general not take effect
until data is written back to the unit using the “WRITE” function.
The procedure to follow for normal programming of unit is:
• Read unit
• Configure parameters (or Open a previously saved
configuration file)
• Write unit
Several modems of the same radio type can be programmed with
the same configuration using the clone facility described in Clone
Mode. It is important to note that when using this facility the cloned
Part I – TVIEW+ Management Suite - Programmer
STEP 2: Installation - TView Diagnostic
Software (Optional)
Note: If a previous version of the “TView WinDiags” software has
been installed on your PC, you must uninstall it via Control Panel
“Add/Remove Programs”.
• Close down all other programs currently running.
• Place the CD-ROM in the drive on the PC.
• Using Windows Explorer open the “Diagnostics” directory on
the CR-ROM.
• Double click on the file called setup.exe
• After the installer starts follow directions.
Other:
The current E Series Manuals are supplied and installed as part
of the TVIEW+ Management Suite installation in Adobe Acrobat
format.
Adobe Acrobat Reader is provided on the CD-ROM for installation
if required.
TVIEW+ Front Panel
When started the TVIEW+ front panel appears. The larger buttons
permit each of the three utilities to be started. The diagnostics
button may be greyed out if this utility has not been installed or
found in the correct file directory. Access to local help and an exit