User's Manual Part 2

7
XDL Micro Intergrator’s Guide
Getting Started
CAUTION – You must handle the XDL Micro transceiver with care during installation. Remove
the transceiver from its protective bag only in an ESD safe area.
To set up the hardware components:
1. Plug the transceiver into the 30-pin connector of an I/O-test board.
2. Attach an antenna to the transceiver using an XDL radio module pigtail data cable.
3. Attach a modem cable to a 9-pin RS232 connector on the I/O-test board.
4. Attach the modem cable to a serial port on the computer.
5. Attach a wall cable to the AC/DC adapter and then select the correct plug from the
adapter kit.
6. Attach the AD/DC adapter’s tubular plug to the power jack on the I/O-test board.
7. Install the XDLCONF software on the computer.
8. Start the XDLCONF software and then connect to the transceiver.
Figure 1 – XDL Micro in test board