User's Manual Part 2

15
XDL Micro Intergrator’s Guide
Appendix A: Mounting Guide
Standard enclosure
The following figure shows mounting holes locations and overall dimensions for the
transceiver.
CAUTION – Screws used to mount the transceiver to a mounting plate must not penetrate
the mounting surface of the transceiver by more than 0.20 inches. Screws that penetrate
beyond this distance may cause damage.
❸
❶
❷
❶
Test fixture tooling hole. Do not use for mounting.
❷
Test fixture tooling hole. Do not use for mounting.
❸
Keepout area both sides. Components and test points located here. .100 inch minimum
clearance.
❶
❶
RF connector. Right angle MMCX.