User's Manual
Table Of Contents
- Product Overview
- Basic Router Setup
- Wireless Networking and Security
- Access Control Filters
- Advanced Router Setup
- Access your router management page
- Change your router login password
- Set your router date and time
- Manually configure your Internet connection
- IPv6 Internet Connection Settings
- Clone a MAC address
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Enable/disable UPnP on your router
- Allow/deny VPN connections through your router
- Allow/deny multicast streaming
- Identify your network on the Internet
- Allow remote access to your router management page
- Open a device on your network to the Internet
- Add static routes to your router
- Enable dynamic routing on your router
- Router Maintenance & Monitoring
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Restart your router
- Check connectivity using the router management page
- Check the router system information
- View your router log
- Configure your router log
- View your router packet statistics
- View wireless devices connected to your router
- Capture packets using the router management page
- Enable SNMP on your router
- Router Management Page Structure
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-731BR
42
Router Maintenance & Monitoring
Reset your router to factory defaults
Tools > Settings
You may want to reset your router to factory defaults if you are encountering difficulties
with your router and have attempted all other troubleshooting. Before you reset your
router to defaults, if possible, you should backup your router configuration first, see
“Backup and restore your router configuration settings” on page 43
.
There are two methods that can be used to reset your router to factory defaults.
• Reset Button – Located on the rear panel of your router, see “Product
Hardware Features” on page 2
. Use this method if you are encountering
difficulties with accessing your router management page.
OR
• Router Management Page
1. Log into your router management page (see “Access your router management page”
on page 27
).
2. Click on Tools and click on Settings.
3. Under Restore factory default settings, click Restore. When prompted to confirm this
action, click OK.
Router Default Settings
Administrator User Name admin
Administrator Password admin
Router IP Address 192.168.10.1
Router Subnet Mask 255.255.255.0
DHCP Server IP Range 192.168.10.101-192.168.199
Wireless Enabled
SSID (wireless network name) TRENDnet731
Wireless Security Disabled
802.11 Mode 2.4GHz 802.11b/g/n mixed mode
Channel Auto Channel