User's Manual

555
This document is intended for Public Distribution
19473 Fraser Way,
Pitt Meadows, B.C. Canada V3Y 2V4
Chapter 3: Configuration
3-5
TR-5A Series
Tranzeo Wireless Technologies
Setup Menu
In this section you would be able to configure wireless and administrative settings
for the TR-5A Series radio.
Wireless Settings
This window displays the wireless configuration of the device. The contents are
slightly different for access point and CPE.
* Feature available only in access point wireless mode.
(1)
In the FCC Domain this setting has no effect.
Wireless Mode:
Define if your device will operate as Infrastructure
Station (CPE) or Access Point.
SSID:
The Service Set Identifier (SSID) is the name that
identifies a specific wireless LAN. Devices must have
the same SSID to communicate with each other. In
Infrastructure Station mode (CPE), you can enter
primary and secondary SSIDs when using two access
points in the network. Clients will connect to the
secondary access point when the primary is
unavailable or goes down.
Visibility Status*:
You can set your access point to be Visible or
Invisible to clients.
Channel*:
Select the channel that the access point and clients use.
TX Rate:
The transmission speed at which the radio and access
point communicate with each other.
Note
: Setting this rate below the maximum possible
does not limit bandwidth and often has a negative
impact on the operation of your network.
Location:
You can set the location of the radio to be Outdoor or
Indoor.
(1)