User's Manual

www.RoperMobile.com CMU056-A1 37
Return To Table of Contents
Operation Guide
Installing the Vehicle Mount (Continued)
Place one of the 2 balls underneath the cradle
and align holes with the receptacles for the
screws.
Tighten all 3 screws to secure balls into place.
Position the second ball against
any solid area in the vehicle.
Secure into place by tightening 4 screws (not
provided).
WARNING
For safety reasons, it is strongly recommended that
the vehicle cradle be installed at level lower than
the driver’s and passenger’s heads.
Using handle, loosen the pin-head adaptor.
Insert each of the balls on either end of the arm.
Adjust cradle to desired angle and secure into
position by tightening the handle.
WARNING
Roper Mobile Technology may not be held
responsible for any injuries caused by the vehicle
cradle or handheld mobile computer in the event of
a collision. The Vehicle cradle has been designed
to withstand normal bumps and vibrations during
travel. It has not been designed to secure the
handheld in case of a collision.
1.
2.
3.
4.
5.
6.
7.
USING VEHICLE CRADLE (CONTINUED)