Installation Instructions

Page 7
GoAnywhere Pass
Audio/Visual Signals
Your GoAnywhere Pass is equipped with audio/visual signals that will alert you about certain conditions
relevant to your tag. Refer to Table 1 for a list of audio and visual signals for your tag.
Notifi cation Indication Audio/Visual Signals
Ready to Go
Indicates tag is ready for
operation
Occurs after fresh batteries
are installed
 x 4
Four quick beeps accompanied by visual signals
LEDs fl ash once in sequence, once together
Low Battery Warning
Indicates low power
Occurs when batteries need
to be replaced
----
Short beeps accompanied by visual signals occur until
batteries are replaced or expended
LEDs fl ash together
Replace Battery*
Indicates battery must be
replaced. Occurs after Low
Battery Warning

No audio signal
LEDs stay steady
Title 21 Acknowledge
(T21 Protocol Only)
Indicates a successful
transaction
Ocurs as the vehicle passes
through a Title-21 toll
installation
 x 2
Two short beeps accompanied by visual signals
LED fl ashes 5 times
Weigh Station Bypass
(ASTM V6 Protocol Only)
Indicates that driver may
bypass the weigh station
Occurs just prior to a weigh
station o -ramp
 x 9
Nine 2-second beeps, accompanied by visual signals
LED stays constant for 6 seconds, then displays 2 two
short fl ashes at 3 second intervals for 15 seconds. The LED
fl ashes every 10 seconds for 15 minutes
Weigh Station Pull-in
(ASTM V6 Protocol Only
Indicates that the driver
must pull into the weigh
station
Occurs just prior to a weigh
station o -ramp
 x 18
Eighteen half-second beeps, accompanied by visual signals
LED stays constant for 6 seconds, then displays 2 two
short fl ashes at 3 second intervals for 15 seconds. The LED
fl ashes every 10 seconds for 15 minutes
* Units with non-replaceable batteries should be returned to the issuing agency for service.
X
Table 1 – GoAnywhere Pass Audio/Visual Signals