Product Manual

INSTALLATION INSTRUCTIONS
WIREWAY ADAPTER
MODEL 3900WW24,28,36,40,48,60,72,84,96,108 AND 120
INSTALLATION
INSTRUCTIONS
CAUTION: Disconnect supply service to baseboard to avoid electrical shock.
All wiring connections must conform to the National Electric Code and local codes having jurisdiction.
1. Remove junction box covers.
2. Remove plug on bottom of junction box and insert the snap bushing provided.
3. Using means to protect heater finish, place baseboard face down. Lay wires in wireway and feed wire
through bushings into junction box allowing 6” min. of wire in junction box.
4. Attach wireway adaptor to baseboard with screws provided.
5. Mount baseboard to wall (refer to baseboard installation instructions).
6. Complete wiring connections inside junction boxes for continuous parallel wiring.
7. Re-install junction box covers and check heater for proper operation.
INSTRUCTIONS FOR PRE-INSTALLED WIREWAY ADAPTER
1. Remove junction box covers.
2. Using means to protect the heater finish, place baseboard face down. Remove the adapter screws
and adapter.
3. Lay wires into bottom of baseboard and feed through bushings into junction boxes allowing 6” min.
of wire into box.
4. Re-install wireway adapter and secure with previously removed screws. Proceed with steps 5, 6
and 7 above.
8923 - REV. 110206
INSTALLATION
INSTRUCTIONS
IMPORTANT: OWNER SHOULD RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
WIRE WAY
BUSHING
SCREW