User's Manual Part 2


Note:
TL-WA7110ND 150Mbps High Power Wireless Access Point User Guide
The firmware version must correspond to the hardware. The upgrade process
takes a few moments and the Device restarts automatically when the upgrade is complete. It
is important to keep power applied during the entire process. Loss of power during the upgrade
could damage the Device.
4.9.7 Factory Defaults
Choose menu System Tools > Factory Defaults, and you can restore the configurations of the
Device to factory defaults on the following screen.
Figure 4-28 Restore Factory Default
Click the Restore button to reset all configuration settings to their default values.

Default User Name - admin.
 Default Password - admin.
 Default IP Address - 192.168.0.254.

Default Subnet Mask - 255.255.255.0.

Note:
All changed settings will be lost when defaults are restored.
4.9.8 Backup & Restore
Choose menu “System Tools > Backup & Restore”, and then you can save
the current configuration of the Device as a backup file and restore the configuration via a
backup file as shown in Figure 4-29.
Figure 4-29 Backup & Restore
Click the Backup button to save all configuration settings to your local computer as a file.
 To restore the AP's configuration, follow these instructions:
1. Click the Browse button to find the configuration file which you want to restore.
2. Click the Restore button to update the configuration with the file whose path is the one you
have input or selected in the blank.

Note:
The current configuration will be covered with the uploading configuration file. Wrong process will
lead the device unmanaged. The restoring process lasts for 20 seconds and the AP will restart
automatically then. Keep the power of the AP on during the process, in case of any damage.
63