User's Manual Part 2

TL-WA7110ND 150Mbps High Power Wireless Access Point User Guide
Figure 4-16 DHCP Settings
 DHCP Server - Selecting the radio button before Disable/Enable will
disable/enable the DHCP server on your AP. The default setting is Disable. If you disable
the Server, you must have another DHCP server within your network or else you
must manually configure the computer.
 Start IP Address - This field specifies the first address in the IP Address pool. 192.168.0.100
is the default start IP address.

End IP Address - This field specifies the last address in the IP Address pool. 192.168.0.199
is the default end IP address.

Address Lease Time - Enter the amount of time for the PC to connect to the AP with its
current assigned dynamic IP address. The time is measured in minutes. After the time is up,
the PC will be automatically assigned a new dynamic IP address. The range of the time is 1 ~
2880 minutes. The default value is 120 minutes.
 Default Gateway (optional) - Enter the IP address of the gateway for your LAN. The factory
default setting is 0.0.0.0.

Default Domain (optional) - Enter the domain name of the your DHCP server.
You can leave the field blank.
 Primary DNS (optional) - Enter the DNS IP address provided by your ISP. Consult your ISP
if you don’t know the DNS value. The factory default setting is 0.0.0.0.
 Secondary DNS (optional) - Enter the IP address of another DNS server if
your ISP
provides two DNS servers. The factory default setting is 0.0.0.0.
Click Save to save the changes.

Note:
To use the DHCP server function of the device, you should configure all computers in the LAN as
"Obtain an IP Address automatically" mode. This function will not take effect until
the device reboots.
4.8.2 DHCP Clients List
Selecting DHCP > DHCP Clients List will enable you to view the Client Name, MAC Address,
Assigned IP and Lease Time for each DHCP Client attached to the device (Figure 4-17).
54